Table of Contents
Advertisement
Mounting the RAU to a wall
Wall mounting
bracket
M6x16 screws
Mounting
bracket A
Key
Surface area of bracket
flush with wall
Figure 14. RAU with wall mounting bracket in place
If desired, the RAU may be mounted to a wall using the wall
mounting bracket shown in Figure 14. This wall mounting bracket is
included in the mounting kit.
1. For this type of installation you will need mounting bracket A,
the wall mounting bracket and the two M6 X 16 mm screws. In
addition, you will need the fasteners recommended in Table 9.
2. Attach mounting bracket A to the wall mounting bracket using
the M6 X 16 mm screws. A detail of the mounting bracket is
shown in Table 2 on page 8.
3. Attach the wall mounting bracket to the wall. The hex bolts used
to connect the wall mounting bracket to the wall must fit the
bracket and be of the appropriate length and type for the
composition of the wall at the chosen installation site.
4. Attach the bottom of the RAU and mounting bracket A using hex
bolts at least 44 mm (1.75 in.) long. Start the hex bolts from the
front of the RAU and continue through the oval holes and on
through mounting bracket A.
M6 x 22 (7/8 in.)
long hex bolt
M6 x 22 (7/8 in.)
M6 x 70
long hex bolt
(1/4 x 2 3/4 in.)
hex bolt
M6 x 70
(1/4 x 2 3/4 in.)
hex bolt
356AA_99.eps
Keep in mind that the entire antenna must have a clear view of the
sky and the horizon in order to operate correctly. The antenna
portion of the RAU must be above the building and not blocked in any
way.
A recommendation of materials needed to anchor the RAU to a
masonry or concrete wall is given in Table 9. These materials are
provided by the installer.
Table 9. Recommended materials for wall mount
Quantity
2
1/4 - 20 x 2 3/4 hex bolt, grade 5 (or metric
equivalent)
2
1/4 - 20 x 7/8 hex bolt, grade 5 (or metric
equivalent)
4
1/4 - 20 machine screw anchors (or metric
equivalent)
4
1/4 SAE flat washer (or metric equivalent)
Mount the RAU on a pole or wall
Type
20
Advertisement
Table of Contents
