Page 2
For many installations no further configuration changes will be required. Changing to IP mode To change the unit to IP mode working (Secure IP) connect a PC to the Ethernet port J600. Link the J903 CONFIG header. Surf to http://192.168.222.222 and click on the “Quick Start”...
Page 3
OR simply configure the unit with a DTMF telephone as follows. Connect a DTMF phone to the dial capture port. (Adapter available from BT Redcare) Link the J903 CONFIG header. Power cycle the unit and wait 15 seconds (6 flashing LED’s) Lift telephone and key # (The unit is now in configuration mode for 5 minutes or until the telephone handset is replaced).
Need help?
Do you have a question about the Secure IP and is the answer not in the manual?
Questions and answers