Connecting The Base Station - Siemens Gigaset 4015 User Manual

Connecting the Base Station

Power supply unit
(110 V AC/60 Hz
with cord )
1
• Insert the
small plug on
cord into
phone jack
• Place cord in
the base cable
channel
• insert power
supply unit
into wall outlet
Key to register
additional
handsets/Page
handsets.
2
• Insert plug on the telephone cord into telephone jack on base unit (clicks
into place)
• Place cord in cable channel on the bottom of the base
• Insert other end of plug into telephone jack on the wall
• The installation of the base unit should allow at least 8 inches between the
base and persons to be in compliance with FCC RF exposure guidelines
• Only use the power supply unit included as indicated on the underside of
the base.
• Use the telephone cord supplied. Do not use any old cords.
• Do not use an outlet controlled by a wall switch.
4
Installing the Telephone System
Telephone jack and tele-
phone cord