Malvern Mastersizer 3000 User Manual page 104

Chapter 4


To report the MESH sizes in the report it is necessary to configure the result table
in a report to use the MESH sizes stored in the User Sizes file rather than microns
sizes. This is done by creating a new result table in a report, and then changing the
properties of the table to report the Size in Sieve Mesh Values.
This will cause the result table to show MESH sizes.
Refer to the reporting chapter for details on creating and saving reports.
Page 4-50
The ISO sieve size sets includes a list of the micron sizes for all of the available
sieves; these sieves are in the same format as the standard Mastersizer size class
files.
The ASTM, BS and Tyler sieve size class files include a MESH reference for
each size class. In this case the list includes the standard microns size, along
with the MESH size in brackets.
Making measurements
MAN 0474