Behringer ULTRADRIVE PRO DCX2496 User Manual page 14

26 ULTRADRIVE PRO DCX2496/ULTRADRIVE DCX2496LE User Manual
6.9 3.0 Channel surround
Stereo sub master
Out 5/6 identic Mono surround channel
In A In B In C In C Signal
Outputs: 1 2 3 4 5 6
EUROPOWER EP2000
Stereo power amplifier
2x mono surround
Stereo high frequencies
Stereo low frequencies
Fig. 6.9: Surround 3.0
With this 3-channel confi guration your audience experiences a live surround sound that comes close to the popular "Dolby Surround" sound format. The 2-way front
speakers carry the main stereo signal from inputs A+B. A separate mono surround signal is supplied via In C, which is reproduced by two rear (or side) full-range
speakers. The surround signal can be a delayed signal derived from the stereo sum signal, it can be processed with reverb or any other eff ect, or it can even provide a
separate sound. Using this confi guration, your surround music performances, slide shows, silent-movies or video shows will be a real experience—the sound of ocean
waves lapping onto the shore or space ships fl ying through outer space—all embedded into "atmo" sounds fl oating around the room.
This scenario does not apply to the DCX2496LE.
Left
Right
XENYX X2222USB Mixing console
Low Full range (mono)
Right (6)
High Left (5)
Surround rear
EUROLIVE B1220 PRO
High
Right (4)
High Left (2)
Surround front
Low Left (1)
Right (3)
Low
27 ULTRADRIVE PRO DCX2496/ULTRADRIVE DCX2496LE User Manual
6.10 Stereo 4-way bridged system plus 2 monitors
XENYX X2222USB Mixing console
Stereo master
left channel
Mono out 1
Mono
out 2
(Sub)
RS-232
In A In B In C
6 5 4 3 2 1 Outputs
EUROPOWER EP2000
Stereo power amplifier
High (4)
High mid (3)
Mid (2)
Low (1)
In B signal (5)
In C signal (6)
Full range
mono monitors
EUROLIVE F1220A
Fig. 6.10: 4-way mono-bridged operation plus 2 monitors (per stereo side)
This application uses one ULTRADRIVE PRO for each stereo side. When both units are coupled to each other via the LINK jacks, and one of them is additionally
connected to a notebook/PC, you can use the computer to remotely control both devices with our free CrossOverRemote Software.
In this example, each DCX2496 is supplied with one side of the main stereo signal (In A). Two additional mono signals are routed from the console to inputs B and
C. Two power amps each are used for the 4-way paths of each P.A. stack, while the third power amp drives two full-range stage monitors. This allows for building a
stereo 4-way system that gives the musicians four on-stage monitors that can be "accessed" individually.
This scenario does not apply to the DCX2496LE.
Mono out 4
Mono out 3
Stereo master
right channel
In A In B In C
LINK
(RS-485)
Outputs: 1 2
4-way
loudspeaker tpwers
(In A signal)
High (4)
High mid (3)
Mid (2)
Low (1)
Left Right
In B signal (5)
In C signal (6)
Full range
mono monitors
3 4 5 6