Behringer ULTRADRIVE PRO DCX2496 User Manual page 11

20 ULTRADRIVE PRO DCX2496/ULTRADRIVE DCX2496LE User Manual
6.3 3x bi-amp operation (LCR/Triple Bi-Amping)
XENYX X2222USB Mixing console
Left
In A In B
Outputs: 1 2 3
Low
High Low
EUROPOWER EP2000
Stereo power amplifier
High (2) High (4)
Left
Low (1) Low (3)
EUROLIVE B1520 PRO
Fig 6.3: 3x2-way operation [LCR/Triple Bi-Amping]
Three 2-way speakers driven from three inputs. Such a setup is used for stage monitors or in cinemas, where, in most cases, the two stereo cabinets (completely to the
left and right) are used to play back music and eff ects, while the center cabinet reproduces voices. Hence the name L-C-R, which stands for "Left-Center-Right".
Note that this scenario will not work for the DCX2496LE as it does not have an INPUT C jack.
Center Right
channel
In C
4 5 6
Low
High High
Mid
High (6)
(Center) Right
Low (5)
21 ULTRADRIVE PRO DCX2496/ULTRADRIVE DCX2496LE User Manual
6.4 Stereo operation plus mono subwoofer
Right
Stereo output
Left
XENYX X2222USB Mixing console
High (1)
EUROLIVE B1800X PRO
B815NEO B815NEO
Left active Right active
loudspeaker loudspeaker
Passive mono subwoofer
SUM (A + B) signal
EUROPOWER EP2000
Stereo power amplifier (mono bridged)
Output 4 usable as additional mono delay line output.
Output 5 + 6 usable as additional stereo delay line output.
Fig. 6.4: Stereo operation plus mono subwoofer
A full-range stereo signal is sent to two active speaker cabinets for stereo reproduction. There is no need for a dedicated frequency separation because the crossover
and amplifi er in the active speaker are perfectly adapted to each other. However, to achieve more power in the bass, low frequencies are cut off in the active cabinets
and routed to a subwoofer. The power amp is set to mono-bridged mode and the SUM signal derived from In A+B is sent to the subwoofer. Outputs 4 to 6 can be used
as mono or stereo delay lines.
In A In B
Outputs: 1 2 3 (4, 5 and 6 not used)
Low (3)