Behringer ULTRADRIVE PRO DCX2496 User Manual page 12

22 ULTRADRIVE PRO DCX2496/ULTRADRIVE DCX2496LE User Manual
6.5 Stereo operation plus 2 subwoofers
Stereo output
In A In B
Out 1 2 3 4 (5 and 6 not used)
EUROPOWER EP2000
Stereo power amplifier
Output 5 + 6 usable as additional mono delay line outputs.
Fig. 6.5: Stereo operation plus 2 woofer cabinets
Only two frequency ranges (Low and High) are used on each stereo side. The two passive speaker cabinets for the higher frequencies are limited towards the bass end
and are fi ne-tuned in their sound with the DCX's internal equalizer. The stereo bass signal is fi rst sent to the active woofer, which also provides the passive woofer
cabinet with suffi cient power for the right-hand low-frequency channel. The unused outputs 5 and 6 can be used as mono delay lines.
Left
Right
XENYX X2222USB Mixing console
EUROLIVE
B1220 PRO
Left passive Right passive
loudspeaker loudspeaker
High (2)
High (4)
EUROLIVE B1800X PRO
Left active subwoofer Right passive subwoofer
Low (3)
Low (1)
23 ULTRADRIVE PRO DCX2496/ULTRADRIVE DCX2496LE User Manual
6.6 Stereo bi-amp operation plus subwoofer and additional monitor
XENYX X2222USB Mixing console
High (2)
High (4)
Left Right
Mid (3)
Mid (1)
In C signal
EUROLIVE F1220A
Full Range mono monitor
Active mono subwoofer
Fig. 6.6: Stereo 2-way operation plus subwoofer and additional monitor
Inputs A+B carry the stereo signal optimized for the two 2-way speakers. The woofer signal is derived from the sum signal of A+B, limited in its frequency range and
routed to the active sub-woofer. A separate signal from the mixing console (aux/subgroup) for a separate speaker can be processed via In C. In our example, this is a
full-range stage monitor with its own amplifi er able to play back a dedicated monitor mix for the singer, drummer or other performers.
This scenario does not apply to the DCX2496LE.
Monitor output
Right
Left
Stereo sub master
In A In B In C
Outputs: 1 2 3 4 5 6
Low (5) SUM (A + B) signal