Table of Contents
Advertisement
2. Ground at an earth ground on the chassis as shown below.
Connect the drain wire to a
chassis mounting tab.
Use any chassis mounting tab
that is designated as a functional
earth ground terminal. This
symbol appears near the tab.
Drain wire with ground lug
3. Connect the insulated wires to the RTB.
Connect ungrounded end of the cable
1. Prepare the non-grounded end of the cable.
A. Remove a length
of cable jacket
from the
connecting cable.
ControlLogix™ Sourcing Current Loop Input Module 9
Chassis mounting tab
B. Pull the foil shield
and bare drain
wire from the
insulated wire.
Allen-Bradley
4M or 5M (#10 or
#12) star washer
4M or 5M (#10 or #12)
phillips screw and star
washer (or SEM screw)
C. Cut foil shield and drain wire
back to the cable casing and
apply shrink wrap, exposing
only the insulated wires.
Publication
1756-IN579A-EN-P - March 2003
20918-M
43182
Advertisement
Table of Contents
