Setting The I/O Chassis Power Supply Configuration Plug; Wiring The Field Wiring Arm - Allen-Bradley D Series User Manual

Chapter 2
Installing Your Module
Setting the I/O Chassis
Power Supply
Configuration Plug
For Use With:
power supply module installed
in chassis
external power supply in your
remote system

Wiring the Field Wiring Arm

2-12
You use the I/O chassis power-supply configuration plug (Figure 2.13) to
identify the type of power supply you use with your remote chassis. This
configuration plug is located on the backplane of series B I/O chassis.
Figure 2.13
Series B I/O Chassis Power Supply Configuration Plug Settings
Set Chassis Configuration Plug to:
Y N
Y" position
Y N
N" position
The field wiring arm provides connection points for:
I/O communication cables
a user-supplied I/O chassis restart pushbutton
The wiring arm pivots on the front of the chassis to connect with the
module's printed circuit board, allowing you to remove the adapter module
without disconnecting the system wiring.
Connect input/output cables to the field wiring arm as shown in
Figure 2.14.
I/O Chassis
Power Supply
Configuration
Plug
Y N
USING
POWER SUPPLY
MODULE IN
THIS CHASSIS?