Installing The Rslinx Activation File - Allen-Bradley ProcessLogix R500.1 Installation Instructions Manual

Installing the RSLinx Activation File

ATTENTION
!
Your ProcessLogix Server is factory loaded with RSLinx Lite. To activate RSLinx OEM
(necessary for full functionality of ProcessLogix) do the following:
1. Locate the RSLinx Master Disk and insert it into the floppy drive.
2. Click Start
3. Enter this path or Browse to:
>A: (or your floppy drive letter)\EVMOVE.EXE<
4. Click OK to launch the move.
5. Confirm that the floppy drive letter A:, for example, appears in the From Drive field
and the hard drive letter C:, for example, appears in the To Drive field in the dialog
box.
6. Click OK to initiate the move.
7. Click Move to move the file to the hard drive.
Wait for a dialog box to give a successful move indication, and click OK to exit.
8. Remove the Master Disk from your floppy drive and store it in a safe place.
TIP
ProcessLogix R500.1 Server Installation Instructions
Before attempting to move the activation file, you MUST exit all
ProcessLogix applications and stop all ProcessLogix services. For
details on this procedure, refer to "Stopping ProcessLogix
Applications and Services" in Chapter 8 of the ProcessLogix R500.1
Installation and Upgrade Guide.
⇒
Run.
If you need to reformat your computer's hard drive, you must first
move the evrsi.sys file back to this Master Disk using this same general
procedure; otherwise, the file will be corrupted.
Publication 1757-IN950A-EN-P - September 2002
9