General Instruction; Preparation Of The Coating Material - WAGNER WOOD&METAL EXTRA LARGE Manual

GB
Read the operating instructions carefully beforeusing the tool and observe the safety
instructions. Keep the operating instructions in a safe place.
The Large spray attachment was developed for applying water-soluble paints and
lacquers as well as paints and lacquers containing solvents.
•
CAUTION! The units may only be used with a functional valve. If paints rises in the
ventilating hose (Fig. 1 A, item 12) do not operate the unit further!
Dismantle and clean the ventilating hose, valve and diaphragm and replace
the diaphragm if necessary.
•
Do not place the spray gun on the side.
•
Do not combine components from different spray attachments.
The parts could be damaged.
1) Gun body
3) Nozzle seal
5) Air cap
7) Material quantity regulation
9) Container seal
11) Container
13) Valve cover
15) O-ring

Preparation of the Coating Material

The Large spray attachment can be used to spray paints, varnishes and glazes that are
undiluted or slightly diluted. Detailed information is available in the technical data sheet
of the manufacturer ( Internet download).
1. Stir the material up and put the required amount into the paint container.
Sprayed material
Glazes
Wood preservatives, mordants, oils, disinfection agents,
plant protective agents
Paints containing solvents and water-soluble paints,
primers, vehicle coating paints, thick-film glazes
2. If the convey capacity is too low, add 5 - 10% dilution step-by-step until the convey
capacity fulfils your requirements.
6

General instruction

Description (Fig. 1)
2) Needle
4) Nozzle
6) Union nut
8) Trigger
10) Feed tube
12) Ventilating hose
14) Diaphragm
Thinning recommendation
Large spray attachment
undiluted
undiluted
dilute by 5 - 10%
(undiluted with Flexio)