Vertiv Cellcorder CRT-400 User Manual page 204

 Connect the Cellcorder to the serial port selected in the
Communications Settings box and power on the Cellcorder.
 If upgrading a previously upgraded Cellcorder (that is, not
running original factory firmware), reset the Cellcorder to
original firmware before continuing the upgrade process. To
determine firmware level: At power up, a Cellcorder running
original firmware displays Boot at the bottom of the display,
then Initializing and the Main Menu. A Cellcorder running
updated firmware displays the revision number then the Main
Menu. To reset the Cellcorder firmware, go to Step 4 or, if the
Cellcorder is running original firmware, go to Step 5. If the user
is unsure of firmware status, it will do no harm to reset it.
 To reset the firmware, if required:
o Power on the Cellcorder.
o Press the Cellcorder <F1> key four times in quick
o At the prompt: Erase RAM program? <Enter>
o Refer to step three and verify the Cellcorder is reset to
 If the Cellcorder is running original firmware, on the computer
click the BAS icon to start the program.
 On the Main Menu, click Device|Cellcorder.
 On the Select Cellcorder box, click CLC–200.
 Verify Communication at the bottom of the Cellcorder Interface
box indicates Connected. On the Cellcorder Interface box, if
required, to change the COM port that communicates with the
CLC, click Change, select a port, then click OK
 In the Firmware Update area, click Load Update.
 On the Upload New Cellcorder Firmware box, go to the
subdirectory with the update file, choose the file, and then click
Open.
 When a valid file is selected, the firmware version prompts for
confirmation before upgrading. For example, Click OK to begin
uploading Version 2.15. To proceed, click OK. Uploading may
take ten minutes. The Cellcorder Interface box estimates time
remaining and displays a message when complete.
4200-002
succession.
Clear <Esc> Quit press <Enter> and wait for the
Cellcorder to re–initialize.
original factory firmware.
186
CLC-200
Revision 6