Charging The Battery - Maxcom MM320 User Manual


After the battery is installed, place back the
back cover and slide it down into position.
2.2

Charging the Battery

Note: Only use the battery included in the set. Using
other batteries might damage the phone and void your
warranty.
Never plug in the charger if the back cover is removed.
To charge the phone:
1. Plug the charger into an electric socket. Plug the
other end of the charger into the jack located at the
top of the phone. A battery icon will start blinking as
soon as the charger is properly connected, and it
will keep blinking while the battery is charging.
2. As soon as the battery is fully charged, unplug
the charger from the electric socket, and then
from the phone.
As soon as charging is complete, there will be a
message on the display: "Charging Complete", and the
icon will stop blinking.
Note:
o
Before you start charging the battery, make
sure the battery is properly installed.
Never remove the battery while charging –
o
doing so might damage the phone.
12