Getting Started; Meter Connection; Connection Established; Home Screen - Geo trio II User Manual

Trio II Touchscreen
. User manual

getting started

Meter connection

The screen will show
Connecting to
for up to 5 minutes
smart meter...
while the monitor connects to the
smart meter(s) in your home.
Should the screen show
No
then you will need to
Network
contact your energy provider to
complete the installation.
If the screen shows
Lost Network,
then you may need to move the
monitor closer to your smart meter(s)
to re-establish the connection.
You can check the strength of
the signal to the smart meter(s) by
looking at the and icons in
l m
the top left hand corner of
the screen.
8

Connection Established

Once your monitor has successfully
established a connection to your
smart meter(s), your Trio II will
show the current consumption for
electricity and recent gas usage.
If your monitor loses connection
to the smart meter(s), then it will
show the alert below. Try moving
the Trio II closer to the smart
meter(s) to re-connect.

home screen

Overview

The screen is broken down
Home
into two or three tabs, depending
on whether you have electricity or
gas in credit or pre-payment mode.
When your Trio II is powered on, it
will automatically show the
Home
screen once connected to the
smart meter(s).
You can also, at any time, press the
button return to the screen.
Home
t
Your meter and WiFi (where
applicable) signal status is shown in
the top left of the screen.
home screen
Use the buttons to switch
u v
between the
Energy now, Energy
or (when in
today Prepay balance
prepay mode) tabs.
When you next return to the
screen from other screens,
Home
the previously selected tab will
automatically be shown.
9