Online Setup; Advanced; Online Setup Introduction; Wifi Module - Geo trio II User Manual

Trio II Touchscreen
. User manual

Advanced

The advanced features include:
Device info
Information including the serial
number and software version of
your Trio II monitor. You may need
this information when contacting
your energy provider.
Usage level
The electricity dial can be scaled to
match the typical usage levels of
your home.
Select from one of the following
options to set the maximum
reading the dial can show:
•
= 12kW
Low
•
(default) = 18kW
Medium
•
= 24kW
High
This option is only available when
you have an electricity smart
meter and the usage level is not
provided by the meter.
24
The dial thresholds between green
to orange, and orange to red are
changed as below in the table.
Usage level Green/orange Orange/red
setting threshold threshold
Low 1.2kW 6.0kW
Medium 1.9kW 9.3kW
High 2.5kW 11.5kW
Low credit setting
Use the buttons to set the minimum
available credit before you receive an
on-screen notification.
This is only shown if you have a
pre-payment meter.
Reset device
Use this screen to remove all your
user settings including budgets,
alerts and credit warning level, WiFi
settings and all consumption.
Engineer
This screen is for installation
engineer use only.

online setup

Introduction
The Trio II may be enabled to
connect to remote cloud services
using an inbuilt WiFi module.

WiFi module

If your Trio II has been supplied
with the optional WiFi module,
then please refer to the Online
Setup Guide that accompanies
this user manual.
To install the module, make sure
the display is disconnected from
the power supply and any batteries
are removed, then remove the
panel from the rear of the display
and insert the WiFi module
online setup

Connect to WiFi network

Your energy display will need to be
connected to a local WiFi network
to enable cloud services.
Access WiFi settings screen
•
Press the button whilst
t
on the Home screen
•
Scroll down to
Settings
and press
w
• Scroll down to
WiFi Network
and press
w
•
Press to turn on the
w
WiFi module
•
Select
Set up network
Connection methods
There are three different ways to
connect to a local WiFi access point:
• Scan for the network
and connect manually
(preferred method)
•
Use another WiFi device - such
as smartphone or laptop - and
connect to the monitor
•
Use the WPS button on your
broadband router
Follow the on-screen instructions
on connecting using one of the
methods above.
25