Specifications; Ec Declaration Of Conformity - Makita DSS610 Instruction Manual

ENGLISH (Original instructions)

SPECIFICATIONS

Model
Blade diameter
Max. Cutting depth
-1
No load speed (min )
Overall length
Net weight
Rated voltage
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heavi-
est combination, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
Battery cartridge
Charger
• Some of the battery cartridges and chargers listed above may not be available depending on your region of
residence.
WARNING:
Only use the battery cartridges and chargers listed above. Use of any other battery cartridges
and chargers may cause injury and/or fire.
Intended use
The tool is intended for performing lengthways and
crossways straight cuts and mitre cuts with angles in
wood while in firm contact with the workpiece.
Noise
The typical A-weighted noise level determined accord-
ing to EN62841:
Model DSS610
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB (A)
Model DSS611
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB (A)
Wear ear protection
Vibration
The vibration total value (tri-axial vector sum) deter-
mined according to EN62841:
Work mode : cutting wood
Vibration emission (a
Uncertainty (K) : 1.5 m/s
at 90°
at 45°
at 50°
) : 91 dB (A)
pA
) : 102 dB (A)
WA
) : 93 dB (A)
pA
) : 104 dB (A)
WA
2
) : 2.5 m/s or less
h,W
2
DSS610
3.0 - 3.4 kg
BL1815N / BL1820 / BL1820B / BL1830 / BL1830B / BL1840 /
BL1840B / BL1850 / BL1850B / BL1860B
DC18RC / DC18RD / DC18RE / DC18SD / DC18SE / DC18SF
NOTE: The declared vibration emission value has
been measured in accordance with the standard test
method and may be used for comparing one tool with
another.
NOTE: The declared vibration emission value
may also be used in a preliminary assessment of
exposure.
WARNING:
The vibration emission during actual
use of the power tool can differ from the declared
emission value depending on the ways in which the
tool is used.
WARNING:
Be sure to identify safety measures
to protect the operator that are based on an estima-
tion of exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it is
running idle in addition to the trigger time).

EC Declaration of Conformity

For European countries only
The EC declaration of conformity is included as Annex A
to this instruction manual.
6 ENGLISH
DSS611
165 mm
57 mm
40 mm
36 mm
3,700
347 mm
2.9 - 3.2 kg
D.C. 18 V