Garmin Vector 2 Quick Start Manual page 12

pursuant to part 15 of the FCC rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
E
equipment generates, uses, and can radiate radio
frequency energy and may cause harmful interference
N
to radio communications if not installed and used in
accordance with the instructions. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment oes cause harmful
interference to radio or television reception, which can
be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by
one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
the receiver.
• Connect the equipment into an outlet that is on a
different circuit from the GPS device.
• Consult the dealer or an experienced radio/TV
technician for help.
This product does not contain any user-serviceable
parts. Repairs should only be made by an authorized
Garmin service center. Unauthorized repairs or
modifications could result in permanent damage to the
equipment, and void your warranty and your authority
to operate this device under Part 15 regulations.
Industry Canada Compliance
Category I radiocommunication devices comply with
Industry Canada Standard RSS-210. Category II
radiocommunication devices comply with Industry
Canada Standard RSS-310. This device complies
with Industry Canada license-exempt RSS
standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference,
and (2) this device must accept any interference,
including interference that may cause undesired
operation of the device.
Product Environmental Programs
Information about Garmin's product recycling program
and WEEE, RoHS, REACH, and other compliance
programs can be found at
aboutGarmin/environment.
12
www.garmin.com/