Troubleshooting - IKEA SKINANDE Manual

EN

TROUBLESHOOTING

Your dishwasher may not work properly.
Before contacting the After-sales Service, check if the problem can be solved by going through the following list.
PROBLEMS
The dishwasher won't
start or does not
respond to commands.
The door doesn't lock.
The dishwasher won't drain.
The dishwasher makes
excessive noise.
The dishes have not been
dried.
The dishes are not clean.
POSSIBLE CAUSES
The appliance has not been
plugged in properly.
Power outage.
The dishwasher door is not closed. Vigorously push the door until you hear the "click".
It does not respond to commands.
Racks are not fit to the end.
The door is not lock.
The wash cycle has not finished yet. Wait until the wash cycle finishes.
The drain hose is bent.
The sink drain pipe is blocked.
The filter is clogged up with food
residues
The dishes are rattling against
each.
An excessive amount of foam
has been produced.
The selected program hasn't any
drying phase.
The rinse aid has run out or the
resolution is not adequate.
The dishes are made of non-stick
or plastic.
The crockery has not been arran-
ged properly.
The spray arms cannot rotate freely,
being hindered by the dishes.
The wash cycle is too gentle
and/or detergent efficiency is low.
An excessive amount of foam
has been produced.( see AFTER-
-SALES SERVICE)
The cap on the rinse aid compart-
ment has not been shut correctly.
The filter is soiled or clogged.
There is no salt.
SOLUTIONS
Insert the plug into the socket.
The dishwasher starts automatically when the power returns.
Switch off the appliance by pressing the ON/OFF button, switch it
back on after approximately one minute and reset the program.
Verify that racks are fit to the end.
Vigorously push the door until you hear the "clack" sound.
Check that the drain hose is not bent (see INSTALATION
INSTRUCTION).
Clean the sink drain pipe.
Clean the filter (see CLEANING THE FILTER ASSEMBLY).
Arrange the crockery correctly (see LOADING THE RACKS).
The detergent has not been measured out correctly or it is not
suitable for use in dishwashers (see FILLING THE DETERGENT
DISPENSER). Reset dishwasher by pressing the DRAIN button
(see OPTIONS AND FUNCTIONS) and run new program without
detergent.
Verify on the programs table if the selected program has the drying
phase.
Add the rinse aid or adjust the dosage levels higher (see FILLING
THE RINSE AID DISPENSER).
It is normal the presence of drops of water (see TIPS).
Arrange the crockery correctly (see LOADING THE RACKS).
Arrange the crockery correctly (see LOADING THE RACKS).
Select an appropriate wash cycle (see PROGRAMS TABLE).
The detergent has not been measured out correctly or it is not
suitable for use in dishwashers (see FILLING THE DETERGENT
DISPENSER). Reset dishwasher by pressing the DRAIN button
(see OPTIONS AND FUNCTIONS) and run new program without
detergent.
Make sure the cap of the rinse aid dispenser is closed.
Clean the filter assembly (see CARE AND MAINTENANCE).
Fill the salt reservoir (see FILLING THE SALT RESERVOIR).
12