Table of Contents
Advertisement
Ninox Camera Quick Start Guide
2.2 Select and attach your lens (300C only)
Select a lens based upon the field of view that is needed for your specific use-case. Refer
to the Section 11.3 of the hardware manual for details on selecting the appropriate lens.
The following fixed-focal length lenses are available for use with this camera:
a. Navitar 3.5 mm
b. Navitar 4.5 mm
c. Navitar 6 mm
d. Navitar 12 mm
Once selected, carefully screw on the lens to the Ninox camera.
2.2.1 Aperture and Focal Adjustment
The C-mount lens used with the Ninox 300C has a set aperture and an adjustable focus.
By rotating the cylinder on the lens labeled 'Near ---- ∞', one can manually adjust the
focus of the lens for each use case.
Note: For extreme cases of bright or dark conditions, the aperture can be manually adjusted. See Section
11.5 of the User Manual for more information.
3 Adjusting your Computer Settings
All changes to the computer settings must be made by a user with Administrator
Power Options
Before using the Ninox camera, the host computer must have the correct power and performance options
set. All computers may not have every Power Option
necessary changes to any option which is listed for your computer:
A note for laptop users: Be sure to change the settings for both On Battery
aware that the settings are all "High Performance" and will reduce the battery run-time.
(Rev A)
Power Option listed below, but you can follow the steps to make the
Power Option
Power Option
On Battery and Plugged In
On Battery
On Battery
Administrator privileges.
Administrator
Administrator
Plugged In modes. Be
Plugged In
Plugged In
4
Advertisement
Table of Contents
