Assembly - Shindaiwa PowerBroom PB2500 Operator's Manual

Assembly: Adjust Throttle Lever Free Play
The throttle lever free play should be
approxiamtely 3/16-1/4 inch(4-6 mm).
See Figure 10. Make sure that the throttle
lever operates smoothly without binding.
If it becomes necessary to adjust the lever
freeplay, follow the procedures and
illustrations that follow.
3/16-1/4 inch (4-6 mm)
Throttle Freeplay
Figure 10
Assembly: Handle
Connect the Handle to the Outer Tube
1. Remove both screws from the handle.
2. While spreading the handle at the
mounting hole, position the handle on
the outer tube as shown.
3. Reinstall the two mounting screws in
the handle, but do not tighten them at
this time.
IMPORTANT!
One side of the handle is recessed to
receive the hex nuts.
4. Locate the handle at the best position
for operator comfort (usually about 10
inches ahead of the throttle lever), and
secure it by tightening the knob at the
handle base.
8
PB2500.05
PB2500.09
Figure 11
1. Loosen the air cleaner cover knob
and remove the air cleaner cover.
See Figure 11.
2. Loosen the lock nut on the cable
adjuster. See Figure 12.
Throttle

Assembly

Figure 13
3. Turn the cable adjuster in or out as
required to obtain proper free play
3/16-1/4 inch(4-6 mm).
See Figure 12.
4. Tighten the locknut.
Cable
Adjuster
PB2500.10
Figure 12
5. Reinstall the air cleaner cover.
Hex Nut
PB10
Outer Tube
Lock
Nut
Handle
Mounting
Screw
Adjustment
Knob
Washer