Assembly - Shindaiwa PowerBroom X7502235300 Owner's/Operator's Manual

Assembly

Prior to assembly
Before assembling, make sure you have all
the components required for a complete
unit:
■
Engine assembly
■
Outer tube assembly
■
Drum kit with gearcase
Connect the Outer Tube to the Powerhead
1. Place the powerhead on a clean, flat
surface, spark plug facing up.
2. Use the 4mm hex wrench to loosen
the index screw and tube clamp
screw. Verify that the D-shaped shim
washer is positioned as shown
CAUTION!
Do not remove the D-shaped shim
washer! The shim washer prevents
damage from overtightening the
tube clamp screw.
3. Add some moly-type EP grease
to the splines on the end of the
mainshaft.
4. Slide the outer tube into the tube
clamp until the tube bottoms. If instal-
lation is difficult, rotate the outer tube
or mainshaft slightly until you feel
the mainshaft splines engage with the
powerhead.
Throttle Cable and Ignition Leads
1. Unscrew the two throttle lever cover
screws, and then separate the throt-
tle control halves as shown.
2. Working from the powerhead, push
the throttle cable through the pas-
sageway in the base of the shaft tube
grip.
3. Insert the throttle cable end into the
molded receptacle in the throttle
lever, and then lay the cable wire in
the molded slot in the throttle body.
4. In the reverse order of removal, reas-
semble the throttle body and cover
on the shaft tube.
5. Plug the red ignition lead from the
shaft tube into the red lead from
the powerhead, and then connect
the black grounding wire to the
powerhead.
6
■
Kit containing operator's handle,
hardware, owner/operator's manual,
tool kit for routine maintenance. Tool
kits vary by model and may inclue a
hex wrench, spanner, and a combina-
tion spark plug wrench/screwdriver.
■
Carefully inspect all components for
damage before assembling.
5. Position the outer tube so that the
ignition switch is facing up and the
throttle trigger is down.
6. Slide the outer tube into the power-
head until the throttle grip just con-
tacts the tube clamp.
CAUTION!
Do not force the shaft tube into
the powerhead! Excessive force
can damage the shaft tube and
7. Tighten the clamp screw firmly.
Cover
screw
Nut
Unscrew and
separate the
throttle control
halves
CAUTION!
Overtightening the throttle assembly
screws can permanently damage
the plastic throttle components!
WARNING!
Do not make unauthorized
modifications or alterations to your
pruner or its components.
Loosen the index screw and
tube clamp screw
Hex
Wrench
Insert outer tube into
powerhead
Index
Screw
Clamp
Shim
Screw
Washer
Insert the throttle cable end into the
Cover
molded receptacle
Throttle cable
Throttle
Molded
cable
receptacle
Throttle
assembly
Connect ignition leads
Ignition lead (red
wire)
Tube Clamp
Screw
Shim Washer
Tube
Clamp
Main
Shaft
Installation
Decal
Outer
Tube
Ground lead
(black wire)
Nylon tube