Table of Contents
Advertisement
Emission Control (Exhaust & Evaporative)
EPA 2010 and Later and/or C.A.R.B. TIER III
The emission control system for the engine is EM/TWC (Engine Modification and 3-way Catalyst) and for the fuel tank
the Control System is EVAP (Evaporative Emissions) or N (for nylon tank). Evaporative emission may be applicable to
California models only.
An Emission Control Label is located on the unit. (This is an EXAMPLE ONLY; information on label varies by en-
gine FAMILY).
PRODUCT EMISSION DURABILITY (EMISSION COMPLIANCE PERIOD)
The 300 hour emission compliance period is the time span selected by the manufacturer certifying the engine
emissions output meets applicable emissions regulations, provided that approved maintenance procedures are
followed as listed in the Maintenance Section of this manual.
assembly
Prior to assembly
Before assembling, make sure you have
all the components required for a com-
plete unit:
■
PowerBroomUnit
Adjustable Handle
This unit comes with the handle
installed. It can be re-adjusted for
operator comfort in the following
manner.
1.
Loosen adjustment knob.
the handle at the best position for
operator comfort (usually about
10 inches ahead of the throttle
lever), and secure it by tightening
the adjustment knob at the handle
base.
6
■
Kit containing hardware, owner/
operator's manual, tool kit for rou-
tine maintenance. Tool kits vary
by model and may inclue a hex
wrench, spanner, and a combina-
tion spark plug wrench/screwdriver.
■
Carefully inspect all components for
damage before assembling.
Locate
The terms "left", "left-hand", and
"LH"; "right", "right-hand", and "RH";
"front" and "rear" refer to directions as
viewed by the operator during normal
operation.
Throttle Assembly
Hex Nut
Outer Tube
WARNING!
Do not make unauthorized
modifications or alterations to your
machine or its components.
iMPORTanT!
Handle
Mounting Screw
Washer
Adjustment Knob
Washer
Advertisement
Table of Contents
