Emission Control; Assembly - Shindaiwa T282 Owner's/Operator's Manual

An Emission Control Label is located on the engine. (This is an EXAMPLE ONLY, information on label varies by
engine FAMILY).
PRODUCT EMISSION DURABILITY (EMISSION COMPLIANCE PERIOD)
The 50 or 300 hour emission compliance period is the time span selected by the manufacturer certifying the
engine emissions output meets applicable emissions regulations, provided that approved maintenance procedures
are followed as listed in the Maintenance Section of this manual.

Assembly

This unit comes fully assembled with the exception of the cutting attachment
shield and cutting attachment.
Prior to Assembly
Before assembling, make sure you have all the components required for a
complete unit and inspect unit and components for any damage.
Front handle installation
Label shows minimum spacing for front handle location.
1. Position front handle for comfortable operation and secure screw.
Cutting Attachment Shield
1. Insert the cutting attachment shield
between the outer tube and the cutting
attachment mounting plate.
NOTE:
It may be necessary to loosen the
retaining nut and clamp screw to adjust
cutting attachment shield mounting plate.
2. Fit the two shims and the bracket over
the outer tube and loosely install the
four socket-head screws.
3. Tighten the four socket-head
cap screws to secure the cutting
attachment shield.
CAUTION!
Make sure the clamp screw and
retaining nut are securely tightened
before tightening the four socket-head
cap screws.
WARNING!
NEVER operate the unit
without the cutting attachment shield
installed and tightly secured!
NOTE:
Socket-Head
Cap Screws
Shim
Clamp Screw
Drain
Screw
■
Engine and shaft assembly
■
Cutting attachment shield
■
Cutting attachment
■
Owner's/operator's manual
■
Assembly Tool(s)
■
Emission Control Warranty Statement
■
Safety Glasses
Support
Handle
Bracket
Shim
Mounting Plate
Retaining
Nut
Outer
Tube
Screw
T282
Outer Tube
Cutting
Attachment
Shield
Line Cutter
7