The amount of the fruit is too little, or the amount of sugar is too much.
When cooking jam, it has
scorched or the kneading blade
Place the bread pan in the sink and half fill the bread pan with warm water. Leave the bread pan to soak until
fixes and it doesn't come off.
the cooked on mixture or kneading blade loosens. After scorching is relieved, wash it with a soft sponge etc.
It can be used for only jam.
Can frozen fruits be used?
White caster and granulated can be used.
What kinds of sugar can we use
Do not use brown sugar, diet sugar, and low calorie sugar or artificial sweetener.
When making jam, can we use
Do not use them. The quality is not satisfactory.
fruits are pickled in alcohol?
This is because the kneading blade fits loosely on the kneading mounting shaft. (This is not a fault.)
The kneading blade rattles.
Unpleasant odours may be emitted during the initial use, it will not emit again under normal operation.
I can smell burning while the
Ingredients may have been spilt on the heating element.
bread is baking.
Sometimes a little flour, raisins or other ingredients may be flicked out of the bread pan during mixing.
Smoke is coming out of the
Simply wipe the heating element gently after baking once the machine has cooled down.
Remove the bread pan from the main unit to place ingredients.
A small amount of dough will escape through the ventilation holes (so that it does not stop the rotating parts from
rotating). This is not a fault, but check occasionally that the kneading mounting shaft rotate properly.
If the kneading mounting shaft does not rotate when the kneading blade is attached, you will need to replace
the kneading mounting shaft unit. (Consult the place of purchase or Panasonic service centre.)
(Bottom of bread pan)
Dough leaks out from bottom of
the bread pan.
Ventilation holes (4 in total)
There has been a power failure for approx. 10 minutes (the plug has been accidentally pulled out, or the breaker
has been activated), or there is another problem with the power supply.
appears on the display.
The operation will not be affected if the problem with the power supply is only momentary.
The machine will operate again if its power is restored within 10 minutes, but the end result may be affected.
When the power supply to machine is interrupted for a certain time, the display shows 1 after recovered. (It is
1 appears on the display and
standby mode and machine could not continue the program.)
operation has been stopped.
Remove the bread, dough or ingredients and start again using new ingredients.
The display indicates a problem with the machine.
H01, H02 appears on the
Consult the place of purchase or Panasonic service centre.
The machine is hot (above 40 °C / 105 °F). This may occur with repeated use.
U50 appears on the display.
Allow the machine to cool down to below 40 °C / 105 °F before using it again (U50 will disappear).
Cause and Action
During or after cooking
mounting shaft unit
Kneading mounting shaft
Part no. ADA29E1651
(Strong bread flour)
Digital timer (up to 13 h)
Dimensions (H × W × D)
Approx. 34.0 × 27.3 × 40.4 cm
Approx. 7.0 kg
Measuring cup, measuring spoon
Disposal of Old Equipment
Only for European Union and countries with recycling systems.
This symbol on the products, packaging, and / or accompanying documents means that used electrical and
electronic products must not be mixed with general household waste.
For proper treatment, recovery and recycling of old products, please take them to applicable
collection points in accordance with your national legislation.
By disposing of them correctly, you will help to save valuable resources and prevent any potential
negative effects on human health and the environment.
For more information about collection and recycling, please contact your local municipality.
Penalties may be applicable for incorrect disposal of this waste, in accordance with national legislation.
max. 500 g
min. 300 g
max. 7.0 g
min. 2.1 g
max. 13.0 g
min. 10.0 g