Sherwood Newcastle R-865 Operating Instructions Manual page 45

Entering a label
• This function can be operated on the input sources
except TUNER, TAPE MONITOR and 8 CH
DIRECT.
Select the desired input source to enter its
1
label.
or
Select the character on the flickering digit.
3
• Each time the MULTI CONTROL knob is rotated,
the characters change as follows:
Blank ( )
Alphabets: A~Z, a~z
Numerals: 0~9
Symbols:
Correcting or clearing a label
Select the desired input source to be
1
rectified or cleared.
or
Press the LABEL button to enter the label
2
input mode.
Example ) When selecting VIDEO 1.
Confirm your selection.
4
• Then the next digit will flicker.
Repeat the above steps
5
the desired characters on the rest of the
digits.
• On up to 9 digits, the desired characters can be entered.
Note: If any of INPUT SELECTOR buttons is
pressed while entering a label, the label input
mode will be canceled.
Memorize the desired label.
6
Repeat the steps
2
label" procedure.
• To clear a label, make a blank on each digit and
memorize it, then the label is cleared and its factory
input source will be displayed.
• If the LABEL button is pressed for more than 3
seconds, blanks will be made on all the digits at
once.
45
and to enter
~ in "Entering a