Sherwood Newcastle R-865 Operating Instructions Manual page 21

Programing the commands from other
remote controls( LEARNING mode )
• If the setup codes are not available for your component
or you want to program a missing or special function
into one button of a device, the learning function
enables this remote control to learn the commands
from other remote controls.
Place this remote control and other remote
1
control facing each other at a distance of 5
to 15 cm (2 to 6 inches ) apart.
5 to 15 cm
(2 to 6 inches)
While "LEARN" is displayed, press the
3
ENTER button.
• Then "SEL" is flickering.
• If "SEL" goes off, start again from the above step
While "READY" is displayed, on the other
5
remote control, press the button of the
function to be learned.
• If the command has been learned successfully,
"OK" is displayed and then "SEL" is flickering.
• If "ERROR" is displayed and then "SEL" is
flickering, it means that for some reason the
command was not learned. In this case, repeat the
above steps and .
Notes :
• If an incorrect signal has been sent or, in some
cases, the command from other remote control
simply cannot be learned.
• In some "ERROR" cases, the remote controls just
need to be moved closer together or farther apart.
Press and hold down the ENTER button
2
and the desired one of the DEVICE buttons
for more than 2 seconds.
• Then "LEARN" is displayed on the LCD screen for
several seconds
Note :
• During setting operation , to exit from the setting
mode, press any of the DIVICE buttons.
While "SEL" is flickering, on this remote
4
control, press the button corresponding to
the function to be learned.
Example) If the function to be learned is playback,
press the PLAY( ) button.
.
• Then "READY" is displayed.
Note:
• You cannot program a function into some buttons
such as DEVICE, MACRO and LIGHT buttons.
While "SEL" is flickering, repeat the above
6
steps
commands you want to the buttons on this
remote control under the same device mode.
To exit from the setting mode, press any of the
DEVICE buttons.
Repeat the above steps
7
the commands from a different remote
control.
Operate the newly programmed buttons to
8
make sure the learning function was
performed properly.
21
and to program all the
to to program