Sherwood NetBoxx R-904N Operating Instructions Manual page 9

_ _ _ J_l o _/€_,._
• I R-904_(A) E_O 09Z007:R-904_(A) 2009-Z0-Z4
o$
Z:53 ..... :I, 7 ,
Speaker placement
ideal speaker placement varies depending on the size of
your room and the wall coverings, etc. The typical example
of speaker placement and recommendations are as follows •
mFront left and right speakers and center speaker
* Place the front speakers with their front surfaces as flush
with TV or monitor screen as possible.
* Place the center speaker between the front left and right
speakers and no further from the listening position than
the front speakers.
* Place each speaker so that sound is aimed at the location
of the listener's ears when at the main listening position.
mSurround left and right speakers
. Place the surround speakers approximately 1 meter (40
inches) above the ear (eve( of a seated listener on the
direct left and right of them or s(ightly behind.
mSurround back left and right speakers
. Place the surround back speakers at the back facing the
front at a narrower distance than front speakers.
* When using a single surround back speaker, place it at the
rear center facing the front at a siight(y higher position (0
to 20 cm ) than the surround speakers.
* We recommend installing the surround back speaker(s) at
a slightly downward facing angle. This effectively prevents
the surround back channel signals from reflecting off the
TV or screen at the front center, resulting in interference
and making the sense of movement from the front to the
back less sharp.
mSubwoofer
* The subwoofer reproduces powerful deep bass sounds.
Place a subwoofer anywhere in the front as desired.
mNotes :
• When using a conventional TV, to avoid interference with
the TV picture, use only magnetically shielded front
left and right and center speakers.
• To obtain the best surround effects, the speakers except
the subwoofer should be full range speakers.
3-qz
1. TV or Screen
2. Front left speaker
3. Subwoofer
4. Center speaker
5. Front right speaker
6. Surround left speaker
7. Surround right speaker
8. Surround back left speaker
9. Surround back right speaker
10. Surround center speaker
11. Listening position
Surround speaker Surround back )
F_,.speaker _ speaker
Point slightly
downward
7, CONNECTING ROOM2 SPEAKERS
. ROOM2 playback feature allows you to play a different
program source in another room as well as one source
in the main room at the same time.
. For ROOM2 playback, connect the ROOM2 speakers
to the SURROUND BACK/ROOM2 terminals.
. Because this receiver cannot drive the surround back
speakers and the ROOM2 speakers simultaneously,
you should assign their power amplifier correctly
depending on how to use them. (For details, refer to
"When selecting the AMP ASSIGN" on page 48.)
/ i •
Main room
Another room (Room2)
_ left
, [-1
©@ ri0h, s0o ko s