Sherwood NetBoxx R-904N Operating Instructions Manual page 27

• IR-.904N(A)_ENG_09100T:R-.904N(A) 200.9-10-14 _-_ 1:53j_]c_
Adjusting the current channel level
, After adjusting each channel level with test tone, adjust the channel levels either according to the program sources or to suit
your tastes. (For details, refer to "When selecting the CHANNEL LEVEL" on page 52.)
1. Select the desired channel.
CH.LEVEL
©
il'd fl 6
. Each time this button is pressed, the channel is selected as
follows:
i L -_ C -_ R -_ SR _ (SBR _ SBL)---]
Front Center Front Surround Surr. Back Surr. Back I
Left Right Right Right Left |
/
SW *- SL _
Subwoofer Surround Left
( ) : Possible only when the surround back speaker is set to
2ch ("x2") or lch ("xl")
* When the channel level disappears, press this button
again.
, Depending on the speaker settings ("NO"), etc., some
channels cannot be selected.
2, Adjust the level of the selected channel as desired.
. The channel levels can be adjusted within the range of
-15 ~ +15 dB.
IlNote:
. When selecting the VuNow as an input source, you
cannot adjust the channel levels.
3, Repeat the above steps 1 and 2 to adjust each channel level.