Description And Technical Specifications - FAAC 630 Manual

The automated system consists of a white beam in aluminium,
with reflex reflectors and a steel upright. The operator is located
inside the upright, and consists of a hydraulic control unit and two
plunging pistons which, by means of a rocker, rotate the beam.
The beam stays balanced thanks to a balancing spring assembled
on one of the plunging pistons. The electronic control unit is also
housed in the upright, inside a waterproof compartment.
The system is supplied with an adjustable anti-crushing safety
device. It also includes a device stopping and locking the beam
in any position, and a handy manual release for use in case of
power cuts or faults.
The 630-630 PLUS-640 automated systems weredesigned
andbuilt to control vehicle access.Do not use for any other
purpose.
1 Beam
2 Travel limit mechanical stop device
3 Drive transmission unit
4 Adjustable travel limit cam RH
5 Adjustable travel limit cam LH
6 Rocker
7 LH travel limit device
8 Oil filling plug
9 Breather screw
10 Cooling fins
11 Piston bleed screw LH
12 Plunging piston LH
13 Hydraulic control unit
14 Feeder pipe LH
15 CLOSING by-pass screw
16 OPENING by-pass screw
17 Upright
18 Hole for cables LH
AUTOMATED SYSTEM 630 - 630PLUS - 640
19 Tie rod
20 Foundation plate
21 Hole for cables RH
22 Earth connector securing screw
23 Cable routing sheath
24 Electronic control board
25 Feeder pipe RH
26 Manual release
27 Spring support position length: 460 mm
28 Protective grid for air intakes
29 Plunging piston RH
30 Spring support position length: 400 mm
31 Balancing spring support
32 Balancing spring
33 Piston bleed screw RH
34 Travel limit device RH
35 Balancing adjustment ring-nut
36 Travel limit mechanical stop device
Fig. 1

1. DESCRIPTION AND TECHNICAL SPECIFICATIONS

TAB. 1 Technical specifications (*)
BARRIER MODEL
Power supply (Vac / Hz)
Absorbed power (W)
Absorbed current (A)
Type of oil
Oil quantity (Lt)
Winding heat protection (°C)
Anti-crushing system
Type of slow-down
Operating ambient temperature (°C)
Hood protective treatment
Hood painting
Protection class
Upright dimensions LxHxP (mm)
(*) For more details about the selected barrier model,
refer to chapter 12
TECHNICAL DETAILS OF 1400 rpm ELECTRIC MOTOR
Power supply (Vac{+6%/ -10%}/Hz)
Absorbed power (W)
Absorbed current (A)
TECHNICAL DETAILS OF 2800 rpm ELECTRIC MOTOR
Power supply (Vac{+6%/ -10%}/Hz)
Absorbed power (W)
Absorbed current (A)

37 Lock
38 Hatch
39 Protective grid for air intakes
40 Cooling fan
(sonly 60 rapid, 640 and 64)
Fig. 2
630 630 PLUS 640
230 {+6%/ -10%} / 50
220
1
FAAC HP OIL
~ 1.8
120
standard by-pass valves
Electronic
-20 / +55
Cataphoresis AISI 316 L
stainless steel
Polyester RAL 2004
IP44
see Fig. 4 and 5
230 / 50
200
1
230 / 50
200
1