Table of Contents
Advertisement
Installation
"FAULT" LED: Indicates faulty wall outlet wiring (improper site wiring, ground is
missing, etc.). If this LED illuminates, see Troubleshooting section.
Note: This LED will illuminate in the presence of most common wiring faults—even a loose
wall outlet—but not necessarily every possible type of fault.
"LINE OK" LED: Indicates the unit is connected to AC input power, the switch
is in the ON position, and the wall outlet is properly wired. If this LED does not
illuminate, see Troubleshooting section.
Connect Your Equipment to the Surge Protector's AC Outlets: Plug your
equipment's power cords into the surge protector's AC outlets. Special pairs of
outlets (Isolated Filter Banks) provide an extra level of filtering between components.
For example, if you plug a receiver into an Isolated Filter Bank outlet, it will not be
affected by interference generated by a DVD player connected elsewhere on the
surge protector. Every outlet pair (two outlets, one above the other, separated by a
screw) is an Isolated Filter Bank. All models feature special widely-spaced outlets to
accommodate transformers without covering other outlets. DO NOT plug in extension
cords. DO NOT OVERLOAD the surge protector's outlets. The surge protector can
accommodate a total equipment load of up to 12 amps (whether plugged into a
single outlet or spread out over multiple outlets). If the load on the surge protector
exceeds 12 amps, the circuit breaker* will trip and the outlets will stop providing
power. If the circuit breaker trips, reduce the load by unplugging some devices.
Depress the circuit breaker or switch to reset the breaker and restore power.
* Circuit breakers are integrated into the power switch on select models and offered as a
separate feature on other models.
Connect Your Equipment to the Surge Protector's USB Charging Ports: Two
USB charging ports deliver up to 5V 3.1A of shared power, enough to charge the most
demanding devices, including tablets, smartphones and MP3 players.
Note: The charging ports are controlled by the master power switch on the unit.
18-07-040-933838-EN.indd 3
3
7/5/2018 4:59:28 PM
Advertisement
Table of Contents
