Table of Contents
Advertisement
14
16 Axis PCI SERCOS interface Card
Access the Computer's PCI Local Bus Expansion Slots
To install the card, you must access the computer's PCI local bus expansion
slots. Refer to your computer's user guide for instructions on how to:
1. Perform an orderly computer shutdown using the operating system
menu.
2. Turn off the power to the host computer and all attached devices.
3. Disconnect the computer from its AC power sources. Disconnect all
other devices in the computer from their power sources. Disconnect
cables such as telephone lines. Doing so reduces the potential for
personal injury and equipment damage.
4. Remove/Open the computer's cover.
5. Select a vacant PCI local bus expansion slot. Make sure the vacant slot
is on the primary PCI Bus. The slot must not be on a bridged or
extended PCI bus.
6. Remove the slot's expansion cover. Remove the screw on the back
(rear bracket) of the computer.
Insert the Card
To insert the card inside the computer:
1. Follow the card handling instructions under Preventing Electronic
Discharge section earlier in this manual.
2. Push the card's PCI connection into the PCI Bus.
3. Set the Card Identification Switch to a unique setting using a small
slotted screwdriver.
4. Replace and tighten the expansion slot screw.
Publication 1784-IN041A-EN-P – June 2003
Advertisement
Table of Contents
