Tannoy CMS 3.0 Series Quick Start Manual page 6

10 CMS 3.0 Series
Installation Guide for Suspended Ceilings
1. Remove the ceiling tile from its frame and place it on a fl at surface. Position the cutout template
(self adhesive backed) on the tile. (Fig.1)
2. Cut out the hole in the ceiling tile using a pad saw following the broken line indicated on the template (Fig.2)
3. Place the C-Ring and tile-bridge on top of the ceiling panel, aligning the C-Ring over the hole, and screw the
C-Ring to the tile bridge using the fi xings provided. (Fig.3)
4. Go to the 'Wiring and Setting Up' chapter.
5. Slide the speaker assembly through the hole. Turn the screws (denoted "Screw Fix") clockwise on the front
of the speaker to extend the mounting wings. Tighten the screws until a fi rm grip is achieved. (NOTE: Screws
have a PoziDriv head; use of a PoziDriv driver is recommended). If using a power driver, TANNOY recommends a
torque setting of 1.5 Nm. (Fig.4)
DO NOT OVERTIGHTEN!
6. Attach the nylon safety to the hooks on the front baffl e before attaching the grille by presenting it to the
speakers and allowing the magnets to pull it into position (Fig.5). (With the CMS 403DCe/ICTe, the grille is
already fi tted to the product.)
NOTE ON INSTALLATION OF CMS 403DCe/ICTe:
Before tightening the screws in step 5, swivel the speaker in the desired direction. When the screws are tightened, the speaker will lock into position. Replace the front
trim to conceal the mounting screws.
Installation Guide for Sheetrock (Plasterboard) Ceilings
1. Position the cutout template (self adhesive backed) on the ceiling. (Fig.1)
Fig.1
2. Cut out the hole in the ceiling using a pad saw following the broken line indicated on the template then slide the
C-Ring into the ceiling, aligning it over the cut-out hole. (Fig.2)
3. Go to the 'Wiring and Setting Up' chapter, then return to point 4 below.
Fig.2
4. Slide the speaker assembly through the hole. Turn the screws (denoted "Screw Fix") clockwise on the front of
the speaker to extend the mounting wings. Tighten the screws until a fi rm grip is achieved. (NOTE: Screws have
a PoziDriv head; use of a PoziDriv driver is recommended). If using a power driver, TANNOY recommends a torque
setting of 1.5 Nm. (Fig.3)
Fig.3
DO NOT OVERTIGHTEN!
5. Attach the nylon safety to the hooks on the front baffl e before attaching the grille by presenting it to the speakers
Fig.4 and allowing the magnets to pull it into position (Fig.4). (With the CMS 403DCe/ICTe, the grille is already fi tted to
the product.)
NOTE ON INSTALLATION OF CMS 403DCe/ICTe:
Before tightening the screws in step 4, swivel the speaker in the desired direction. When the screws are tightened, the speaker will lock into position. Replace the front
trim to conceal the mounting screws.
Fig.5
Quick Start Guide 11
Fig.1
Fig.2
Fig.3
Fig.4