Preparation For Use - Sharp MD-MX10H Operation Manual

PREPARATION FOR USE

Unplug the AC power lead from the AC socket before
connecting or disconnecting any component.
Aerial connection
1
AM loop aerial
2
Supplied FM aerial
Connect the FM aerial wire to the FM 75 OHMS socket
and position the FM aerial wire in the direction where the
strongest signal can be received.
Supplied AM loop aerial
Connect the AM loop aerial wire to the AM LOOP socket.
Position the AM loop aerial for optimum reception.
Place the AM loop aerial on a shelf, etc., or attach it to a
stand or a wall with screws (not supplied).
Notes:
Do not place the aerial on the main unit as it may result in
noise pickup from the internal digital electronics.
Place the aerial away from the unit for better reception.
If the AM loop aerial and the FM aerial wire are placed
near the AC power lead, interference may result.
External FM aerial
Use an external FM aerial if you require better reception.
Consult your dealer.
External FM aerial
Speaker connection
FM aerial
Right
Connect each speaker wire to the SPEAKER terminals
as shown.
Use speakers with an impedance of 6 ohms or more, since
lower impedance speakers can damage the unit.
Notes:
Connect the black wire to the minus (–) terminal, and the
red wire to the plus (+) terminal.
Do not mix the right channel and left channel wiring when
connecting the speakers to the unit.
Do not let bare speaker wires touch each other as this may
damage the amplifier and/or speakers.
The speaker grille is not detachable.
6
Black
Red
1
2
Left
Red
3