System Preparation; Installing The Sound Bar - Sharp HT-SB32D Operation Manual

System preparation

Make sure to unplug the AC power cord before
installing the sound bar or changing the position.
To mount the sound bar on the wall
Caution:
Be very careful to prevent the sound bar [5.1 lbs.
●
(2.3 kg)] from falling when mounting on the wall.
Before mounting, check the wall strength. (Do not
●
put on the veneer plaster or whitewashed wall. The
sound bar may fall.) If unsure, consult a qualified
service technician.
Mounting screws are not supplied. Use appropri-
●
ate ones.
Check all wall mount angle screws for looseness.
●
Select a good location. If not, accidents may occur
●
or the sound bar may get damaged.
SHARP is not responsible for accidents result-
●
ing from improper installation.
■ Driving screws
SHARP designed the sound bar so you may hang
it on the wall. Use proper screws (not supplied).
See below for size and type.
1/8" (3.2 mm)
3/16"
3/8" (9 mm)
(5 mm)
Min. 7/8" (22 mm)

■ Installing the sound bar

1
Fix the pattern paper to the wall in hori-
zontal position as below.
21-5/8" (548 mm) 509 mm
Wall surface
44 mm
Pattern paper
(supplied)
2
Make a hole on the wall following the screw
point marks on the pattern paper by using
a drill.
3/8" (8-9 mm)
3
Fix a wall mount plug into the hole using
a hammer, until it is flush with the wall
surface.
1-1/4" (32 mm)
3/8" (8-9 mm)
4
Fasten the screws to the wall as shown below.
(Total screw is 2 pieces)
Wall surface
Wall surface
5
Hang the sound bar onto the screws.
E-8
1-1/4" (32 mm)
Wall surface
Wall sur
face
Screw using
screwdriver
3/16" (4.5 mm - 5 mm)
Gap from wall
surface