Beko WM 6103 W Installation & Operating Instructions Manual page 32

You may not be using
proper detergent for
automatic washing
machines.
Excessive amount of
detergent may have been
used.
Too much detergent may
have been used for a small
amount of lightly soiled
laundry.
Detergent may have been
stored improperly.
Type of material being
There is too
washed (lace items will
much foam.
cause excessive foam due
to their meshed structure).
Detergent might have
been put in the wrong
compartment.
Softener being released
early.
The plug might not be
plugged in the mains outlet.
Machine does
Fuse may have blown.
work. No light
Electricity may be cut off.
is on.
The "On/Off" button might
have not been pressed.
The machine
did not start
after the
program was
selected and The front door may be ajar.
the 'Start/
Pause/Cancel'
button was
pressed.
"Washing"
and "Start/
Pause/Cancel"
Water may have been cut
lights are
off.
flashing after
the program is
started.
It shows the safety period
The "Lid" light
until the door lock is
is flashing.
opened.
Use only automatic washing machine detergents in
your washing machine.
Use only sufficient amount of detergent.
Use only sufficient amount of detergent.
Store detergent in a closed and dry location. Do
not store in excessively hot places.
Use smaller amounts of detergent for lace items.
If you put detergent in the prewash compartment
although you have not selected a prewash cycle,
the machine can take this detergent during rinsing
or softener step.
You may have added too much softener.
The detergent dispenser might be problematic.
Water may be siphoned (pulling the softener into
the washer early) during the fill or rinse cycles.
There might be problems with the valves.
Plug should be checked.
Fuse should be checked.
Power should be checked.
This button must be pressed.
You can restart your machine by pressing the
"Start/Pause/Cancel" button for a short time after
ensuring that the water is not cut off.
For your safety, the front door can only be opened
2 minutes after the program is completed. The
"Lid" light will flash during this period.
32
EN