Page 1
Automatic washing machine WM 6143 S WM 6133 W WM 6143 W WM 6133 S...
Page 2
Please read this user manual first! Dear Customer, We hope that you get the best results from the product which has been manufactured in state-of-the-art plants and passed through a strict quality control procedure. Therefore, please read the entire user manual carefully before using the product and keep it as a reference for future use.
Your washing machine Overview 1- Power cable 5- Adjustable feet 2- Top panel 6- Loading door 3- Control panel 7- Detergent drawer 4- Filter cap 8- Drain hose...
Technical specifications Models Maximum dry laundry capacity (kg) Height (cm) Width (cm) Depth (cm) Net weight (±4 kg.) Electrical input (V/Hz) 230 V / 50Hz Total current (A) Total power (W) 2200 Spin speed (rpm max.) 1400 1300 1400 1300 Technical specifications may be changed without prior notice to improve the quality of the product.
Important safety instructions This section contains safety instructions injury from hot water will occur. that will help protect from risk of personal • Do not force open the locked loading injury or property damage. Failure to follow door. The loading door will be ready these instructions shall void any warranty.
Page 7
let them to tamper with the product. Use child lock to prevent children from intervening with the product. • Do not forget to close the loading door when leaving the room where the product is located. • Store all detergents and additives in a safe place away from the reach of the children.
Installation Refer to the nearest Authorised Service Removing packaging Agent for installation of the product. To reinforcement make the product ready for use, review Tilt the machine backwards to remove the information in the user manual and the packaging reinforcement. Remove the make sure that the electricity, tap water packaging reinforcement by pulling the supply and water drainage systems are...
3. Attach the plastic covers supplied in the User Manual bag into the holes on the rear panel. (P) Keep the transportation safety bolts in a safe place to reuse when the washing Ensure that the cold and hot water machine needs to be moved again in connections are made correctly when the future.
• In case the hose is elevated after laying it on the floor level or close to the ground (less than 40 cm above the ground), water discharge becomes more difficult and the laundry may come out excessively wet. Therefore, follow the heights described in the figure.
fuse. Connect the green - yellow or green (earth) wire to the terminal in the plug • The specified voltage must be equal to marked ‘E’ or with the symbol f or your mains voltage. coloured green and yellow or green. •...
Disposing of the old product anti-limescale into the main wash detergent compartment (compartment nr. Dispose of the old product in an II). If the anti-limescale is in tablet form, environmentally friendly manner. put only one tablet into compartment nr. Refer to your local dealer or solid waste II.
Preparation Things to be done for energy saving Following information will help you use the product in an ecological and energy- Wash with sensitive, Washing water efficient manner. .short programmes temperature • Operate the product in the highest capacity allowed by the programme you have selected, but do not overload;...
and the washing programme desired. The machine automatically adjusts the amount of water according to the weight of the loaded laundry. Follow the information in the “Programme and consumption table”. When overloaded, machine's washing performance will drop. Moreover, noise and vibration problems may occur. Laundry types and their average weights in •...
Using detergent and softener • When washing dark coloured clothes and quilts, it is recommended to use Detergent Drawer liquid detergent. The detergent drawer is composed of three • Wash woolens with special detergent compartments: made specifically for woolens. - (I) for prewash Use only detergents manufactured - (II) for main wash specifically for washing machines.
Page 16
detergent between the laundry, close to the lower part of the drum in future washings. Use the tablet or gel detergent without selecting the prewash function. Using starch • Add liquid starch, powder starch or the dyestuff into the softener compartment as instructed on the package.
Turning the machine on For further programme details, see, Prepare the machine for programme “Programme Selection Table” selection by pressing the “On/Off” button. When “On/Off” button is pressed, “Ready” Main programmes light illuminates indicating that the door is Depending on the type of textile, the ready to be opened.
Page 19
• Delicates You can wash your delicate clothes on this programme. It has more sensitive washing movements and does not make intermediate spinning compared to the synthetic programme. It must be used for clothes for which sensitive washing is recommended. •...
Auxiliary functions Use this function for delicate laundries Auxiliary function selection keys that crease easily. Select the required auxiliary functions Whenever you select this auxiliary before starting the programme. function, load your machine with half of Auxiliary function buttons may differ the maximum laundry specified in the according to the model of your programme table.
When the same button is pressed unlocked. again, 6 hours; and if pressed once You can put your machine into “Pause” more, 9 hours delay will be selected. If mode by pressing the “Start/Pause/ the time delaying button is pressed one Cancel”...
Ending the programme The spin speed and temperature which through cancelling are selected first will keep on being The programme which is selected first will valid even if the position of the spin keep on going even if the position of the speed or temperature selection knob is programme selection button is changed.
Maintenance and cleaning inside of the bellow with a clean piece of Service life of the product extends and cloth after the programme has come to an frequently faced problems decrease if end. cleaned at regular intervals. Repeat Drum Cleaning process in every Cleaning the detergent drawer 2 months.
the water in the machine cools down. 2. Open the filter cap. If the filter cap is composed of two pieces, press the tab on the filter cap downwards and pull the piece out towards yourself. 1. Close the taps. 2.
Page 26
is emptied, repeat the above procedure to drain the water in the machine completely. c. When draining of water is finished, close the end by the plug again and fix the hose in its place. d. Turn the pump filter to take it out. Discharging the water when the product does not have an emergency draining hose:...
Troubleshooting Programme cannot be started or selected. • Washing machine has switched to self protection mode due to a supply problem (line voltage, water pressure, etc.). >>> Press and hold Start / Pause / Cancel button for 3 seconds to reset the machine to factory settings. (See "Canceling the programme") Water in the machine.
Page 28
Loading door cannot be opened. • Door lock is activated because of the water level in the machine. >>> Drain the water by running the Pump or Spin programme. • Machine is heating up the water or it is at the spinning cycle. >>> Wait until the programme completes.
Page 29
Machine does not switch to spinning step. • There might be an imbalance of laundry in the machine. >>> Automatic unbalanced load detection system might be activated due to the unbalanced distribution of the laundry in the drum. Machine does not switch to spinning step when the laundry is not evenly distributed in the drum to prevent any damage to the machine and to its surrounding environment.
Page 30
Washing performance is poor: Clothes smell unpleasantly. • Odours and bacteria layers are formed on the drum as a result of continuous washing at lower temperatures and/or in short programmes. >>> Leave the detergent drawer as well as the loading door of the machine ajar after each washing.
Page 31
Detergent residue in the detergent drawer. • Detergent is put in wet drawer. >>> Dry the detergent drawer before putting in detergent. • Detergent has gotten damp. >>> Keep detergents closed in an environment free of humidity and do not expose them to excessive temperatures. •...
Page 32
Laundry remains wet at the end of the programme • Excessive foam might have occurred and automatic foam absorption system might have been activated due to too much detergent usage. >>> Use recommended amount of detergent. Machine does not switch to spinning step when the laundry is not evenly distributed in the drum to prevent any damage to the machine and to its surrounding environment.
Republic of Ireland. items. • The guarantee is applicable only to • The labour costs of a Beko approved new products and is not transferable if repairer to carry out the repair. the product is resold. • Beko disclaims any liability for What is not covered? incidental or consequential damages.
Should you experience any difficulty in require attention under guarantee. obtaining service please contact the Beko Customer Help-Line. You should also complete the details Tel: 0845 600 4911 below;...