Chapter 3 Hardware Installation; System Requirements; Hardware; Operating Systems/Distributions - Mellanox Technologies ConnectX-5 User Manual

3 Hardware Installation
3.1

System Requirements

3.1.1 Hardware

A system with a PCI Express x16 slot is required for installing the card.
3.2

Operating Systems/Distributions

Please refer to

3.2.1 Software Stacks

Mellanox OpenFabric software package MLNX_OFED for Linux, and WinOF-2 for Windows.
See Chapter 4, "Driver
3.3

Safety Precautions

1. Remove any metallic objects from your hands and wrists.
2. Make sure to use only insulated tools.
3. Verify that the system is powered off and is unplugged.
4. It is strongly recommended to use an ESD strap or other antistatic devices.
3.4

Pre-Installation Checklist

1. Verify that your system meets the hardware and software requirements stated above.
2. Shut down your system if active.
3. After shutting down the system, turn off power and unplug the cord. Remove the card from its
package. Please note that the card must be placed on an antistatic surface.Check the card for
visible signs of damage. Do not attempt to install the card if damaged.
Rev 1.5
Unless otherwise specified, Mellanox products are designed to work in an environmentally
controlled data center with low levels of gaseous and dust (particulate) contamination.
The operation environment should meet severity level G1 as per ISA 71.04 for gaseous
contamination and ISO 14644-1 class 8 for cleanliness level.
Section 1.3, "Operating Systems/Distributions", on page
Installation".
The adapter is being installed in a system that operates with voltages that can be lethal.
Before opening the case of the system, observe the following precautions to avoid injury and
prevent damage to system components.
Mellanox Technologies
Hardware Installation
11.
14