Turning The Projector On/Off; Connecting The Power Cord; Turning The Projector On; Turning The Power Off - Sharp XG-P610X Operation Manual

Turning the Projector On/Off

Connecting the Power Cord

Plug the supplied power cord into the
AC socket on the rear of the projector.
Then plug into the AC outlet.

Turning the Projector On

Before performing the steps in this section,
connect any equipment that you use with the
projector. (See pages 24–27.)
Remove the lens cap and press ON on the
projector or on the remote control.
• The power indicator illuminates green.
• After the lamp indicator illuminates, the projec-
tor is ready to start operation.
• When System Lock is set, the keycode input
screen appears. Enter the right keycode to
start projection. See page
Note
• The lamp indicator illuminates or blinks, in-
dicating the status of the lamp.
Green: The lamp is on.
Blinking green: The lamp is warming up.
Red: The lamp is shut down abnormally
or the lamp should be replaced.
• When switching on the projector, a slight flick-
ering of the image may be experienced within
the first minute after the lamp has been illumi-
nated. This is normal operation as the lamp's
control circuitry is stabilizing the lamp output
characteristics. This does not indicate malfunc-
tion.
• If the projector is put into standby mode and
immediately turned on again, the lamp may
take some time to illuminate.

Turning the Power Off

ting the Projector into Standby Mode)
Press STANDBY on the projector or on
the remote control, then press that but-
ton again while the confirmation mes-
sage is displayed, to put the projector

into standby mode.

-28
60 for details.
(Put-
Supplied
accessory
Rear view
To AC socket
Info
• When "Auto Restart" is set to "On":
If the power cord is unplugged from the AC outlet or the
breaker switch is turned off when the projector is on,
then the projector automatically turns on when the power
cord is plugged into the AC outlet or the breaker switch
is turned on. (See page 63.)
• English is the factory preset language. If you want to change
the on-screen display to another language, change the lan-
guage according to the procedure on page 65.
ON button
STANDBY
button
▼On-screen display
Info
• You can unplug the power cord from the AC outlet even if
the cooling fan is still running. Even if you unplug the power
cord from the projector, the cooling fan continues to run
for a while.
Power cord
To AC outlet
Power cord
STANDBY button
ON button
Power indicator
Lens cap Lamp indicators1, 2