CHASSIS-Gas Tank, Rear Swing Arm
2)Make sure that the rear cushion moves up and
down completely from bottom to top.
4-7 Gas Tank
A. Removing
1) Pull out the seat fitting pin and remove the seat by
pulling 1t backward
2)Set the petcock lever at the "Stop" pos1t1on and
disconnect the fuel line at the petcock
Fig 4-6-2
Fig 4-7-1
Fig 4-7-2
3)Next. remove the tank holding bolt and remove the tank by pulling it backward.
(13 mm)
4-8 Rear Swing Arm
The rear swing arm is made of steel tubing that improves the strength and torsional rigidity. The
pivOl
employs
permanently lubricated bearings.
- 5 8 -