Yamaha JT1 Series Service Manual page 55

5)Repairing the brake shoe
If
the brake
shoe
has uneven contact with the bra'ke
drum or scratches, smooth out the surface With
sandpaper or hand file If the surface is glazed
use the file to remove the hard smooth finish.
6)!f the tire is excessively worn. replace it.
?)Regularly check the tires for damage.
8)
1f
the bearings allow excessive play in the wheel
or
if
it does not turn smoothly, replace the bearing.
9) Replace a bent or damaged front wheel axle.
1 O) Check the lips of the seals for damage or war page.
Replace if necessary.
Replacing the Wheel Bearing
a.
First clean the outside of the wheel hub.
CHASSIS-Front Wheel, Rear Wheel
Fig 4-1-9
b. Insert the bent end of the special tool (as shown in Fig. 4-1-11) into the hole located in the center of the bearing
spacer. and drive the spacer out from th0 hub by tapping the other end of the special tool with a hammer.
(Both bearing spacer and spacer flange can easily be removed.)
c. Then push out the bearing on the other side
d. To install the wheel bearing, reverse the above sequence. Be sure to grease the bearing before installation and
use the bear mg fitting tool (available from Yamaha.)
1.
2.
3.
4.
2
5.
Fig. 4-1-10
Hub
Bea,1ng (6202RS)
Spacer flange
Bearing spacer
Bearing (6202RS)
- 4 9 -
Insert the bent end of the
special tool into the hole
located in the center of
the bearing spacer.
Fig. 4-1-11