Editing; Error Messages - Sharp MD-MT821 Operation Manual

E r r o r m e s s a g e s
l The battery run down.
B a t t EMPTY
(Lo BAT-T)
l Nothing is recorded.
B L A N K D I S C
( B L A N K )
l No
Can't COPY
SCMS copyright system.
(Not REC)
l A track cannot be edited
Can't EDIT
l Recording cannot be performed
Can't REC
correctly due to vibration or shock in
(Not REC)
the unit
l Editing is impossible.
Can't WRITE
l The disc is scratched.
D E F E C T
( D E F E C T )
Din l Poor connection of the digital cable.
U N L O C K
( U N L O C K )
l
The disc
DISC FULL
l Improper power is being supplied.
POWER ?
l The MD is write protected.
l You tried to record without loading an
MD.
P R O T E C T E D
l A playback-only MD was loaded and
the REC button was pressed when the
Power was off.
l The disc is damaged.
R E A D E R R O R
l
Since a track number is currently being
located or written to, the unit cannot
l You have come to the conclusion that
STEM ERR
(E-SYS)
the unit is out of order.
l The temperature is too high.
EMP OVER
;E-TEMP)
l A large portion of the disc has been
TOC ERROR
damaged.
(E-TOC)
l The trac
Protect
Tr.
being erased
l A large portion of the disc has been
TOC ERROR
damaged.
(E-UTOC)
l There is an error
l
Adiscn
DISC
?
music was
l There is an e r r
(?DISC)
disc.
( ): Error messages seen on the remote control.
M e a n i n g
copy can be made because of the
out of recording space.
IS
c e
ation (track names,
e e c t .
k has been protected from
in the recorded s i g n a l
which contains data other than
played
o r the signal from the
R e m e d y
l Charge the rechargeable battery or
replace the alkaline battery (or use the
AC adaptor for p o w e r
l Replace the disc with a recorded disc.
l Record using the analog cable.
l Change the stop position of the track
and then try editing It.
l
Re-record or replace It with another
recordable disc
l Check the number of tracks.
l If the sound you hear is not right, try
recording again
l replace the disc with another
recordable d i s c
l Connect the digital cable securely.
l Replace it with another recordable disc.
l Use one of the specified power
sources.
l
Move the write protection knob back to
its original position.
l Load a recordable MD.
l Replace it with a recordable MD.
l Reload the disc or replace It.
l Replace it with another recorded d i s c
l Wait for a while and try the operation
l To have it repaired, go to the distributor
where you purchased the unit.
l Turn off the power, and wait for a while.
l Replace it with another recorded disc.
r e p l a c e it with another recordable d i s c
l edit the track with the device on which
i t w a s recorded
.
l Replace it with another recorde
try recording again
l A disc which contains non-music data
c a n be played
l R e place it with another recorded disc.
d d i s c