Sharp MD-MT821 Operation Manual page 39

MiniDiscs are recorded using a different system than is used for cassette tapes or DAT
recordings. Therefore, the following conditions may be encountered, depending on how
the disc has been recorded or edited. These are due to system limitations, and should be
considered normal.
Even if the maximum recording
time of a MiniDisc has not been
reached, "DISC FULL" or "TOC
FULL" may be displayed.
Even if the number of tracks and
t h e r e c o r d i n g t i m e h a v e n o t
reached the limit, "DISC FULL"
may be displayed.
Even if several short tracks are
erased, the remaining recording
time may not show an increase.
Two tracks may not be combined
in editing.
The total of the recorded time and
time remaining on a disc may not
add up to the maximum possible
recording time.
When recorded tracks are played
back using the cue and review op-
erations, some sounds may be
skipped.
A track number can be created in
the middle of a track.
When the number of tracks used
reaches the limit, regardless of the
remaining recording time, further
recording will be impossible.
(Maximum number of tracks: 255)
If a MiniDisc has been recorded or
edited repeatedly or if a MiniDisc has
scratches on it, it may not be possible
to record the maximum number of
tracks on it.
If there are scratches on a disc, the unit
will automatically avoid recording in
those areas. The recording time will be
reduced.
When the remaining recording time of
a disc is displayed, short tracks less
than 12 seconds long may not be
included in the total.
For MiniDiscs on which repeated
recording and editing operations were
performed, the COMBINE function
may not work.
A cluster (about 2 seconds) is normally
the minimum unit of recording. So, even
if a track is less than 2 seconds long, it
will use about 2 seconds of space on the
disc.
Therefore, the time actually available for
recording may be less than the
remaining time displayed.
If there are scratches on discs, those
sections will be automatically avoided
(no recording will be placed in those
sections). Therefore, the recording time
will be reduced.
For MiniDiscs on which repeated
recording and editing were performed,
some sounds may be skipped while
cueing and reviewing.
If there are scratches or dust on a
MiniDisc, the track numbers following
that track will be increased by one.
3 8