About The Toc - Sharp MD-MT821 Operation Manual

After recording:
n
Press the /:OFF button while in the stop
mode.
on the disc, the power will shut off auto-
matically. (For details about the TOC,
see page 20.)
To remove the MiniDisc:
Turn off the power and move the OPEN
lever in the direction indicated by the arrow.
following situations:
(commercially available music)
dental erasure (page 9)
about the recording level:
back sound volume may be too low to
hear well. If it is too high, the playback
sound may be greatly distorted. Since
digitally recorded CDs have a large dy-
namic range (the volume can vary tre-
mendously from very soft to extremely
loud), do not set the recording level any
higher than is necessary.
Precautions when recording:
recording. Otherwise, the recording
may be unusable.
(Manual recording)
Manual recordings can be started and
stopped as you like.
1
Place the unit in the recording stand-by
mode. (Perform steps 1 -- 4 in the "Syn-
chro recording" section.)
2 Press the )I1 button.
button, and then start playback on the
equipment connected to this unit.
recording. (Page 17)
To interrupt recording:
Press the )II button while recording.
by mode.
ton again.
The track number will be increased by
one each time you interrupt a record-
ing.
playback signal in the original record-
ing, the new recording may not begin
or pause at the correct point when in
the synchro mode. If this happens, try
making a manual recording.
Precautions when inserting a MiniDisc:
of the edge of the disc while holding it
parallel to the main unit.
force the MiniDisc into the unit. It may
additional more problems. If resistance
is felt, remove the MiniDisc and try re-
loading it.
Notes:
l
Whenever any button is pressed, the
remote control display will light for ap
proximately 7 seconds.
11