INIM Electronics PREVIDIA MAX Manual page 12

Icon
Sounder status
Configuration
status
Alarm
communicator
status
Fault-
communicator
status
Home
12
Selecting this icon will access (at level 2) a menu which allows manual deactivation,
activation and silencing of all fire alarm signalling devices.
Fire-alarm signalling devices (sounders, etc.) are in standby status and are
At least one fire alarm signalling device is in fault status. Contact your service
At least one fire alarm signalling device is disabled
At least one fire alarm signalling device has been activated
No hardware anomalies on the control panel
A hardware problem has been detected inside the control panel (module
malfunction). Contact your service dealer.
If installed, remote alarm-signalling devices (telephone diallers or communicators
to alarm receiving centres) are in standby status and operating efficiently.
A fault has occurred on a remote alarm-signalling device. Contact your service
An alarm communicator has been disabled.
A remote alarm-signalling device is operating (transmitting a communication)
An alarm communication has been sent and confirmed by the recipient
An alarm communication has been sent but not confirmed by the recipient
If installed, remote fault-signalling devices (telephone diallers or communicators to
alarm receiving centres) are in standby status and operating efficiently.
A fault has occurred on a remote fault-communicator device.
A fault communicator has been disabled.
A remote fault-signalling device is operating (transmitting a communication)
A fault communication has been sent and confirmed by the recipient
A fault communication has been sent but not confirmed by the recipient
Indicates the current date and time, selection of this area accesses (at level 2) the
Allows users to go directly to the home template or, when events are active, from
the home template to the active events template.
Function
operating properly.
dealer.
dealer.
date and time setting section.
Fire detection and extinguishant system
User interface