Subscribe to Our Youtube Channel
Related Manuals for RenewAire HE1.5XRTV
Summary of Contents for RenewAire HE1.5XRTV
- Page 1 INSTALLATION, OPERATION & MAINTENANCE MANUAL ENERGY RECOVERY VENTILATOR HE1.5XRT MODEL: HE1.5XRT WWW.RENEWAIRE.COM...
- Page 2 Never locate the unit inside a structure. Danger of damage or severe injury if high winds move this unit. Secure unit to structure. Observe local code requirements at a minimum. WWW.RENEWAIRE.COM 1.800.627.4499 INSTALLATION, OPERATION AND MAINTENANCE MANUAL...
-
Page 3: He1.5Xrt Info
8: Unit Control Codes "V", "E" & "F" not available with Voltage Code "1". NOTE: RenewAire reserves the right to make changes in the design or specifications of products at any time without notice. Unless otherwise specified, dimensions are rounded to the nearest eighth of an inch. - Page 4 Roof curb - standard 14" 615 lbs. Download specification at: Curb wind clip Motor(s): renewaire.com/specifications Engineered combo curb for Carrier RTU Qty. 2, 1.0 HP ea., Direct drive standard motorized Engineered combo curb for Trane RTU impeller packages Digital time clock - wall mount (TC7D-W),...
- Page 5 DESCRIPTION OF OPTION CODE MOUNTING OPTION DUCT CONNECTION CONFIGURATION Room Air [RA] enters bottom of unit. HE1.5XRTV Roof Curb Fresh Air [FA] exits bottom of unit. Room Air [RA] enters bottom of unit. HE1.5XRTR Roof Curb Fresh Air [FA] exits side of unit.
- Page 6 WWW.RENEWAIRE.COM WWW.RENEWAIRE.COM 1.800.627.4499 1.800.627.4499 INSTALLATION, OPERATION AND MAINTENANCE MANUAL INSTALLATION, OPERATION AND MAINTENANCE MANUAL RENEWAIRE.COM FOR THE MOST COMPLETE AND CURRENT INFORMATION VISIT...
- Page 7 SPECIFICATIONS & DIMENSIONS 1.800.627.4499 INSTALLATION, OPERATION AND MAINTENANCE MANUAL WWW.RENEWAIRE.COM RENEWAIRE.COM 1.800.627.4499...
-
Page 8: Installation
See Rigging Information for unit weight. building. The equipment is put out of service and the FA (RTR) collateral damage can be very expensive. RenewAire strongly recommends that you secure 18" X 18" rooftop units properly to the building structure. Duct Receiving... - Page 9 4/22/09 MF Scale: 1" = 24" HE1.5XRT Corner Weights SPECIFICATIONS SUBJECT HE1.5XRT UNIT CORNER WEIGHTS (LBS) TO CHANGE WITHOUT NOTICE. Do not scale drawing MAY18- MHK SPECIFICATIONS RenewAire LLC HE1.5X-RT_CORNER_WEIGHTS_ SINGLE-WALL MAY18.dwg CURB 1.5X PHASE UNIT 4 1/4" 1-PHASE & 3-PHASE 17 1/8"...
- Page 10 These guidelines are consistent with SMACNA recommended duct layout practices for efficient and quiet air movement. Follow SMACNA guidelines. WWW.RENEWAIRE.COM 1.800.627.4499 INSTALLATION, OPERATION AND MAINTENANCE MANUAL...
- Page 11 - Clean out the interior of the unit to remove any debris. the impeller blades. - Install energy exchanger cores, filters, and core strap. www.renewaire.com (800) 627- 4499 support@renewaire.com 1.800.627.4499 INSTALLATION, OPERATION AND MAINTENANCE MANUAL...
- Page 12 APPLICATIONS See figure F4 for examples of some common installation approaches. Common Installation Approaches info@solidworks.com info@solidworks.com CONDITIONED SPACE info@solidworks.com WWW.RENEWAIRE.COM 1.800.627.4499 INSTALLATION, OPERATION AND MAINTENANCE MANUAL...
- Page 13 Duct(s) connected to the bottom of the HE1.5XRT are generally installed at this time. Install (2) ducts with HE1.5XRTV, (1) duct with HE1.5XRTR or RTF. MOUNTING THE UNIT - OPTIONAL CURB CLIPS...
- Page 14 DO NOT INSTALL JUMPER BETWEEN TERMINALS 2 & 3 "EA" = Exhaust Air Blower 24VAC OUT Class II FACTORY WIRING HIGH-VOLTAGE RELAY FACTORY WIRING 24VAC 24VAC FIELD WIRING HIGH-VOLTAGE Call for Unit Operation. FIELD WIRING 24VAC WWW.RENEWAIRE.COM 1.800.627.4499 INSTALLATION, OPERATION AND MAINTENANCE MANUAL...
- Page 15 "EA" = Exhaust Air Blower 24VAC OUT Class II FACTORY WIRING HIGH-VOLTAGE RELAY (FA) RELAY (EA) FACTORY WIRING 24VAC Call for FA Blower Operation. 24VAC FIELD WIRING HIGH-VOLTAGE Call for EA Blower Operation. FIELD WIRING 24VAC 1.800.627.4499 INSTALLATION, OPERATION AND MAINTENANCE MANUAL WWW.RENEWAIRE.COM...
- Page 16 Wire Gauge of the motor thermal protection. Circuit Length 100’ 150’ 250’ 400’ 700’ 1000’ “Circuit Length” is distance from ERV to Control Device. WWW.RENEWAIRE.COM 1.800.627.4499 INSTALLATION, OPERATION AND MAINTENANCE MANUAL...
- Page 17 Terminal 1. Connect the other side of the output contacts to the appropriate yellow leads: Terminal 4 for the “FA Blower”, and Terminal 5 for the “EA Blower”. A SWITCH OR NON-POWERED CONTROL USING UNIT’S 24VAC POWER SUPPLY 1.800.627.4499 INSTALLATION, OPERATION AND MAINTENANCE MANUAL WWW.RENEWAIRE.COM...
- Page 18 Dampers are open, the power draw of the Damper Actuators is allowed to be as much as 35VA while opening (including power draw of the external control system, if any). However, the power draw of the fully-opened (stalled) Actuators (and external control system if any) must be less than 8VA. WWW.RENEWAIRE.COM 1.800.627.4499 INSTALLATION, OPERATION AND MAINTENANCE MANUAL...
- Page 19 They already have une utilisation avec regulateur de vitesse electronique. speed control built into the motor electronics. Ils ont déjà le contrôle de vitesse intégré dans le moteur électronique. 1.800.627.4499 INSTALLATION, OPERATION AND MAINTENANCE MANUAL WWW.RENEWAIRE.COM...
-
Page 20: Start-Up
NOTE: Pressure drop of clean 2” MERV-8 Filters is included in the Unit Performance Ratings Table. MEASURING AIRFLOW Pressure Taps (4) RTH, RTR RTV, RTF ONLY ONLY RTV, RTF ONLY RTV, RTR ONLY WWW.RENEWAIRE.COM 1.800.627.4499 INSTALLATION, OPERATION AND MAINTENANCE MANUAL... - Page 21 INITIAL PRESSURE DROP OF MERV13 FILTERS AVAILABLE AS AN OPTION. Filters available for this unit 0.40 0.30 0.20 0.10 0.00 1000 1200 1400 1600 Unit Airflow (CFM) NOTE: pressure drop of standard filter is included in unit airflow performance tables 1.800.627.4499 INSTALLATION, OPERATION AND MAINTENANCE MANUAL WWW.RENEWAIRE.COM...
-
Page 22: Maintenance
HE1.5XRT MAINTENANCE SERVICE PARTS HE1.5XRT www.renewaire.com (800) 627- 4499 support@renewaire.com WWW.RENEWAIRE.COM 1.800.627.4499 INSTALLATION, OPERATION AND MAINTENANCE MANUAL... - Page 23 Use caution, motor may be hot. The motor must cool before it resets the thermal protector. If the motor thermal protector tripped, correct the issue that caused the motor to overheat (e.g. over motor rated amperage or locked rotor). 1.800.627.4499 INSTALLATION, OPERATION AND MAINTENANCE MANUAL WWW.RENEWAIRE.COM...
- Page 24 ABOUT RENEWAIRE For over 30 years, RenewAire has been a pioneer in improving people’s health, cognitive function, productivity and wellbeing by enhancing indoor air quality (IAQ) in homes and buildings of every type. This is done energy-efficiently, cost-effectively and sustainably via our fifth-generation, static-plate, enthalpy-core Energy Recovery Ventilators (ERVs) and Dedicated Outdoor Air Systems (DOAS) that reuse otherwise-wasted energy to condition incoming outdoor air.
Need help?
Do you have a question about the HE1.5XRTV and is the answer not in the manual?
Questions and answers