Operation Of Touch Control Panel; Before Operating; Sound Setting; Stop/Clear - Sharp MODEL R-2197 Operation Manual

OPERATION OF TOUCH CONTROL PANEL

The operation of the oven is controlled by pressing the appropriate pads arranged on the surface of the control
panel.
An entry signal tone should be heard each time you press the control panel to make a correct entry.

Before Operating

• When you first connect the microwave oven to an
electrical socket, the digital display will show
.
• Key pad entries can only be made when the door
is shut.

Sound Setting

• There is a choice of 2 different sounds and no
sound on your oven.

Stop/Clear

• If you want to stop the oven during cooking:
1. Press the STOP/CLEAR pad once.
2. Open the door (except memory cooking).
To start the oven again, close the door and press
the START pad within 1 minute.

MEMORY OPERATION

• This oven has 20 memory banks (1-20) which can
store cooking programmes.
• The memory banks 1-0 have been programmed
previously as shown in the table. These prepro-
grammed memory banks can be changed indi-
vidually if required.
• In addition for all memory banks a time constant
1.7 for the double quantity is stored. The stored
time constant can also be changed individually if
required.
• Information in these memory banks is not lost due
to power interruptions. If the power goes off, the
oven does not need to be reprogrammed. No bat-
teries are necessary for this type of memory.
• If you want to cook using memory 11-20, press
the desired NUMBER pad twice within 1 second.

Cooking with Memory

* Suppose you want to cook by using memory 1, which was programmed for 10 seconds at 100%.
Step
1
Press the NUMBER pad
Procedure
.
• The programme or check mode is cancelled when
any pads are not pressed for more than 3 min-
utes.
• will appear on the display after the time
reaches zero. It will disappear when the oven door
is opened or the STOP/CLEAR pad is pressed.
• To set signal, touch the SET pad twice within 2
seconds and then touch the SIGNAL pad continu-
ously until you hear desired tone.
• If you open the door during memory cooking, the
programme is cancelled.
• If you want to cancel a programme during cook-
ing, press the STOP/CLEAR pad twice.
• If you want to clear a mistake during program-
ming, press the STOP/CLEAR pad once.
Memory No.
Cook Time
1
10 sec.
2
20 sec.
3
30 sec.
4
45 sec.
5
1 min.
6
1 min. 15 sec.
7
1 min. 30 sec.
8
2 min.
9
2 min. 30 sec.
0
3 min.
To check the stored programmes please refer to
"Memory check" on page 9.
To change the stored programmes please refer to
"Memory programme entry" on page 6.
Pad Order
5
Output Power
100%
100%
100%
100%
100%
100%
100%
100%
100%
100%
Display
NO.
After about 1 sec.
ON