Table of Contents
Advertisement
THIS MANUAL SHOULD BE RETAINED FOR FUTURE REFERENCE
Congratulations on your purchase of APW Wyott Modular Assembly Pack Station. APW Wyott takes pride
in the design and quality of our products. When used as intended and with proper care and maintenance,
you will experience years of reliable operation from this equipment. To ensure best results, it is important
that you read and follow the instructions in this manual carefully.
Before installing and operating this equipment be sure everyone involved in this operation is fully trained
and is aware of all precautions. Accidents and problems can result by a failure to follow fundamental rules
and precautions.
The following words and symbols, found in this manual, alert you to the hazards to the operator, service
personnel or the equipment. The words are defined as follows.
WARNING: This symbol refers to a potential hazard or unsafe practice, which could result
!
in serious injury or death.
CAUTION: This symbol refers to a potential hazard or unsafe practice, which may result in
!
minor or moderate injury or product or property damage.
NOTICE: This symbol refers to information that needs special attention or must be fully
!
understood even though not dangerous.
CAUTION: These models are designed, built, and sold for commercial use. If these
models are positioned so the general public can use the equipment make sure that
!
cautions, warnings, and operating instructions are clearly posted near each unit so that
anyone using the equipment will use it correctly and not injure themselves or harm the
equipment.
IMPORTANT: We strongly recommend having a licensed electrician install this
!
equipment. The electrician should be familiar with all local and national codes.
WARNING: Check the data plate on this unit before installation. Connect the unit only to
!
the voltage and frequency listed on the data plate. Connect only to 1 or 3 phase as listed on
the data plate.
WARNING: Electrical and grounding connections must comply with the applicable
!
portions of the national electrical code and/or other local electrical codes.
WARNING: Disconnect device from electrical power supply and place a Tag Out-Lockout
!
on the power plug, indicating that you are working on the circuit.
WARNING: A factory authorized agent should handle all maintenance and repair. Before
!
doing any maintenance or repair, contact APW Wyott.
WARNING:
!
An earthing cable must connect the appliance to all other units in the complete
installation and from there to an independent earth connection.
GENERAL INFORMATION
SAFETY PRECAUTIONS
2
!
!
!
!
!
!
!
!
!
!
Advertisement
Table of Contents
