Cisco Connection Online - Cisco 6200 Installation And Replacement

78-5294-02 10/02/98
Table 1
J1
J2
J3
J4
J5
You need a Phillips screwdriver to install the dangler cables. Follow these steps:
Step 1
Step 2
Step 3
Step 4
Step 5
4.2 Removing Dangler Cables from the Cisco 6200
Follow these steps to remove dangler cables from the back of the Cisco 6200 DSLAM. You need a
Phillips screwdriver to perform this procedure.
Step 1
Step 2
Step 3
Step 4

5. Cisco Connection Online

Cisco Connection Online (CCO) is Cisco Systems' primary, real-time support channel. Maintenance
customers and partners can self-register on CCO to obtain additional information and services.
Available 24 hours a day, 7 days a week, CCO provides a wealth of standard and value-added
services to Cisco's customers and business partners. CCO services include product information,
product documentation, software updates, release notes, technical tips, the Bug Navigator,
configuration notes, brochures, descriptions of service offerings, and download access to public and
authorized files.
Dangler Cables Mapped to SLC Slots
J6
Slot 5 Slot 10
J7
Slot 6 Slot 11
Slot 7 J8 Slot 12
J9
Slot 8 Slot 13
Slot 9 J10 Slot 14
Use a Phillips screwdriver to unfasten one of the two metal panels that cover the Champ
connectors on the back of the Cisco 6200. Each panel is held in place by six Phillips-head
quarter-turn fasteners. Turn each fastener 90 degrees in either direction to release it.
Attach dangler cables to the five connectors (see Figure 4). Secure the cables with the
wire clips attached to the backplane connectors.
Route the dangler cables toward the sides of the chassis: two to one side, three to the other.
Replace the metal cover and use a Phillips screwdriver to fasten it in place. Turn each
fastener 90 degrees in either direction to secure it.
Repeat this procedure, if necessary, to install dangler cables behind the other panel.
There are six Champ connectors behind the bottom panel. Do not attach a dangler
Note
cable to the Champ connector located above and to the right of the other five connectors.
See Figure 4.
Use a Phillips screwdriver to unfasten one of the two metal panels that cover the dangler
cables on the back of the Cisco 6200. Each panel is held in place by six Phillips-head
quarter-turn fasteners. Turn each fastener 90 degrees in either direction to release it.
Unfasten the two wire clips holding each dangler cable in place, and then pull the cable
off the connector.
Replace the metal cover and use a Phillips screwdriver to fasten it in place. Turn each
fastener 90 degrees in either direction to secure it.
Repeat this procedure, if necessary, to remove the dangler cables behind the other panel.
Cisco 6200 FRU Installation and Replacement
Cisco Connection Online
13