Rolling - Central Machinery 05907 Assembly & Operating Instructions

Step 7. Bend the fourth side.
Step 8. Using a block or piece of wood, tap the corner of material back into place.
a c e . a p l p l

Rolling

Step 1:Move the COVER (#33) back and out of the way.
Step 2:Drop the BACK PRESSING ROLL (#24) by loosening the SCREW (#25).
Step 3:Insert just the leading edge of your workpiece between the UPPER PRESSING ROLL
(#32) and LOWER PRESSING ROLL (#31), and tighten the roll bar gap ADJUSTABLE
BOLT (#27) until the ROLL BARS are barely snug against the workpiece.
Step 4:Advance the SCREW (#25) as much as desired depending upon the tightness of the roll
to be accomplish. (The tighter the roll, the more the knobs must be advanced.)
Step 5:Crank the HANDLE ASSEMBLY (#18 & 26) until the proper roll has been achieved. The
material should feed itself through the rollers as you crank the HANDLE ASSEMBLY.
Page 10 -- SKU: 05907
Figure 8 — Pan Forming
Step 2: Bend Second Side
REV 11/02