Advertisement
4
VEHICLE PREPARATION
1. Using a 10mm socket/ratchet, disconnect the negative
battery terminal. (FIGURE A)
NOTE: Do not disconnect the battery cable from the
battery post.
2. Open the glove box and press inward on the sides of
the glove box to disengage the retaining tabs from the
glove box inner cover. Disconnect the strut from the
glove box. (FIGURE B)
3. Using a panel removal tool, carefully remove the right
side dashboard panel by starting at the bottom access
notch and working upward to disengage four (4) pressure
clips. (FIGURE C)
4. Using a panel removal tool, carefully lift upward to
disengage (4) pressure clips and one (1) fi nger clip
and then pull rearward to remove the passenger's side
ornament panel. (FIGURE D)
5. Using a Phillips screwdriver, remove seven (7) Phillips
screws securing the glove box inner cover. Disengage
the six (6) pressure clips and disconnect the glove box
lamp connector to remove the glove box inner cover.
(FIGURE E)
FIGURE D
ISSUE
PART NUMBER
H001SFL300
DATE
00
22 Jun 2018
FIGURE A
FIGURE B
FIGURE C
FIGURE E
SUBARU OF AMERICA
2 OF 7
Advertisement
